Operation
Getting Ready (continued)
3. Remove the collection tank from the unit by opening the Quick Release Hose Door and lifting the tank straight up by the handle.
4. Remove the top lid from the collection tank and set aside.
5. Fill the collection tank to the fill line (located
on side of tank) with clean, cold water.
6. Replace the top lid back onto the top of the collection tank.
7. Set the collection tank back in the machine.
8. Select "WATER FILTER VACUUM" with the mode selector.
9. Close the Quick Release Hose Door tightly until it clicks into the locked position.
10. Plug into a proper outlet and press the ON/ OFF button down into the ON position.
Emptying the tank
1. Open the Quick Release™ Hose Door and remove the collection tank by lifting straight up with the tank handle.
2. Remove the top lid from the collection tank and set it aside.
3. Empty dirty water into a sink or toilet, or outside. Pour the dirty water out from the corner of the tank. Rinse out the tank thoroughly.
4. Refill the tank if needed and replace the top lid back onto the top of the collection tank.
5. Set the collection tank back in the machine.
6. Close Quick Release hose door tightly until it clicks into locked position.
7. If finished vacuuming, refer to the Maintenance and care section starting on page 14.
Wet cleaning
Before you clean
1.Plan activities to give your carpets time to dry.
2.Thoroughly dry vacuum the area to be cleaned.
3.Plan your cleaning route to leave an exit path. It is best to begin cleaning in the corner farthest from your exit.
w w w . b i s s e l l . c o m
3
5
7
4
6
8
8 0 0 . 2 3 7 . 7 6 9 1 | 169 |
10/30/07 3:39:26 PM |