Troubleshooting
Reduce Spray or No Spray
Possible Cause
1.Make sure power is on
2.Solution tank may be empty
3.Tank may not be seated properly
4.Hose solution line may be disconnected
5.Wet clean is not turned on
WARNING:
To reduce the risk of fire, electric shock or injury unplug from outlet before servicing.
Remedies
1.Press power button if needed
2.Fill tank according to directions
3.Turn ON/OFF, heater and wet clean button off. Remove and reseat tank
4.Check connection at front of machine
5.Depress wet clean button to turn on
Machine is not suctioning
Possible Cause
1.Collection tank may not be placed properly
2.Collection tank may not be assembled properly
3.Wand tool connections are not tight
4.Collection tank is full
5.Float has tripped
6.
Remedies
1.Open Quick Release™ Hose Door, lift out tank and
2.Check to make sure the top lid is properly seated
3.Check all connections (At grip, wand and tool) Push tight if necessary
4.Empty collection tank by following instruction on page 9
5.Check to see if tank needs to be emptied. Make sure float is down towards bottom of tank
6.Remove top lid. Remove and clean
Filter must be completely dry before using again
Built-in heater light does not illuminate
Possible Cause | Remedies | ||
1. | The heater button has not been depressed | 1. | Depress the heater button |
2. | The ON/OFF button has not been depressed | 2. | Depress the ON/OFF button |
Other maintenance or service not included in the manual should be performed by an
authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
16 w w w . b i s s e l l . c o m
8 0 0 . 2 3 7 . 7 6 9 1
10/30/07 3:41:00 PM |