Bissell 68Z3 warranty Cleaning the pre-motor filter

Maintenance and care

Cleaning the inner cyclone & screen continued

6.The tank may also be wiped clean with a damp cloth. Make sure the tank is completely dry before reassembling.

7.To reassemble, hold the carry handle and place the screen back onto the top portion of the dirt container. Be sure to align the notch on the top with the insert on the flat edge of the screen. Then place the inner cyclone back into the screen by aligning the notches at the top of the inner cyclone with the inserts inside the screen and turning counter clockwise to lock into place.

8.Place the top portion back onto the dirt container by grasping the carry handle and turning clockwise to lock into place. Be sure that the dirt container release button is aligned with the emptying button when locked into place.

Cleaning the pre-motor filter

The pre-motor filter protects the motor from dirt and dust particles. Use only BISSELL replacement filters in your CleanView Dual Cyclonic.

1.Turn the power OFF. Unplug the vacuum from the electrical outlet.

2.Remove the dirt container from the vacuum.

3.The pre-motor filter is located behind the door labeled “FILTER” on the main body of the vacuum. Open the door by pushing up on the tab at the bottom of the door and pulling out to remove.

4.Remove the filter tray by pulling up on the tab of the tray. Remove the pre-motor filter and set aside. Tap the tray gently over a trash can to remove any dirt or debris.

5.The pre-motor filter can be washed in cold water with a mild detergent. Rinse well and air dry thoroughly before placing back into the tray.

6.Place the tray back into the vacuum and replace the filter door by inserting the tabs at the top of the door and pushing down until it clicks into the locked position.

10

w w w . b i s s e l l . c o m

NOTICE:

This product is intended for household use only and not for commercial or industrial use. Vacuuming of dust from products like plaster, concrete or ashes will damage the motor and void the warranty.

3.

4.Pre-Motor Filter

Filter Tray

Tip:

For maximum cleaning performance, check the filters often and clean or replace if necessary.

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.