Troubleshooting
Vacuum cleaner won’t run
Possible causes
1.Vacuum cleaner is not plugged in
2.Power button is not pressed down
3.Thermal protector activated
WARNING:
To reduce the risk of electric shock, turn power OFF and dis- connect plug from electrical outlet before performing maintenance or troubleshooting.
Remedies
1.Check electrical plug
2.Press power button down
3.Allow vacuum to cool for 1 hour, see page 12
Vacuum cleaner won’t pick up or low suction
Possible causes | Remedies | ||
1. | Tools, hose and/or telescoping extension wands are blocked | 1. | Remove each part and check for blockages |
2. | Filters are dirty | 2. | Check and clean or replace |
3. | Dirt container is full | 3. | Empty dirt container |
4. | Hose not securely attached to suction opening | 4. | Make sure hose connector is locked into |
|
|
| suction opening |
5. | Crack or hole in flex hose | 5. | Check hose and replace if needed |
6. | Air flow regulator or variable suction power | 6. | Change to closed or maximum setting |
| control is set to open or minimum setting |
|
|
Visible dust escaping from vacuum |
|
| |
Possible causes | Remedies | ||
1. | Dirt container is full | 1. | Empty dirt container |
2. | Filters missing or installed incorrectly | 2. | Check |
3. | Filters are dirty | 3. | Check and clean or replace |
4. | Flex hose is blocked | 4. | Remove hose and check for blockages |
5. | Hose not securely attached to suction opening | 5. | Make sure hose connector is locked into suction opening |
6. | Crack or hole in flex hose | 6. | Check hose and replace if needed |
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
13
w w w . b i s s e l l . c o m