Rheem PTG53-(PVN)(PVP)(XN)(XP), RUTG2-53(PVN)(PVP)(XN)(XP) warranty Water Temperature Setting…

Page 28

Notice: The remote control cannot be turned on when water is flowing or circulating through the water heater.

Water Temperature Setting…

Maximum water temperature occurs while the burner is on. To determine the water temperature, turn on a hot water faucet and place a thermometer in the water stream. Water temperature at the faucet may vary depending on season and length of pipe from the water heater.

The factory setting of the remote control temperature range is between 100°F (38°C) and 120°F (49°C).

The remote control is factory preset to 100°F (38°C).

To turn the remote control ON or OFF, press the POWER button.

To adjust the temperature to a required setting, press the UP arrow temperature button.

Pressing the UP or DOWN temperature adjustment buttons will change the temperature set point.

The temperature set point on the remote control cannot be increased above 112°F (44°C) when a hot water faucet is in the open position.

Notice: The factory setting allows operating temperatures between 100°F (38°C) and 120°F (49°C). Temperatures of up to 140°F (60°C) can be achieved with the MAIN (UMC-117) remote control and a dip switch adjustment. Only qualified service personnel should perform this adjustment. Only factory authorized remote control(s) should be used.

The hottest temperature water will be at the hot water faucet closest to the water heater.

Always remember to test the water temperature with your hand before use and remember that hotter water increases the risk of scald injury.

Always supervise young children or others who are incapacitated.

The water heater is equipped with a device that will shut off the gas supply to the burner if the water heater exceeds normal operating temperatures. Refer to the “Before You Call For Service” section located near the back of this manual, or contact your dealer.

!WARNING: Should overheating occur or the gas supply fail to shut off, turn off the manual gas control valve to the appliance.

If the water heater has been subjected to fire, flood, physical damage, or has been under water, turn off the manual gas shut-off valve(s), and do not operate the water heater again until it has been checked by qualified personnel.

Notice: The water heater may not operate with a small water flow. In such case, increase the water flow. If water heater still does not operate and hot water faucet is completely open, increase the temperature setting on the remote control.

Notice: Display shows °F only.

In Use Indicator

 

Priority Indicator

 

 

(Lit during operation)

 

 

 

PRIORITY

Temperature

LED Display

 

(Displays water

°F

Adjustment

temperature and error

Buttons

 

codes)

 

 

 

POWER

ON/OFF

 

ON/OFF

Indicator

 

 

 

 

Higher (Hotter)

 

 

Lower (Cooler)

100 102 104 106 108 110 112

114 116 118 120*

125 130 135 140

°F

38

39

40

41

42

43

44

46

47

48

49*

52

54

57

60

°C

*Temperatures above 120°F (49°C) can be achieved by adjusting the dip switch. See page 35 for dip switch adjustment.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Tankless Water Heater That will result in death or serious You can find them on a label on the applianceInjury Install and Properly Vent the Water HEATER… N G E R Natural GAS and Liquefied Petroleum Models Read and Follow this Safety Information Carefully Installing the Outdoor water heater Location of the Outdoor water heaterInstalling the Indoor water heater Location of Indoor Water HeaterCorrosive Atmospheres Combustion and Ventilation Air Indoor Water Heater OnlyInspect Shipment Venting Venting LengthsMaximum Vent Length Minimum Vent Length The ventingAppliance Vent Adapter Venting Through Closed SpacesDraining the Condensate Installing the water heater Horizontal Vent Terminal LocationIndoor Water Heater Outdoor Water HeaterAdditional Considerations Vent Horizontal Wall Thimble Installation Vertical Vent Installation Vertical Vent Termination LocationThermal Expansion Mounting the Water HeaterWater Supply Connections Water Filter Clean Water Inlet Check Valve Nipple Relief Valve Leak Testing Pressure Testing the Gas Supply SystemGas Supply High AltitudeRemote Control Installation ControlModel Description Range NumberRemote Control ExtensionWall CablePenetration Suitable Indoor water heaters only Electrical ConnectionIndoor or Outdoor water heaters Indoor Models Outdoor ModelsHot and Cold Pipe Insulation Installation During Installation of this water heater…Insulation Blankets Do’sInstallation Check List Lighting the water heater To Turn OFF GAS to ApplianceSafety Precautions Water Temperature SettingTime/Temperature Relationship in Scalds Operating the water heaterWater Temperature Setting… Housekeeping Routine Preventative MaintenanceDrain heater. See Draining Water Heater section on Venting System Inspection Burner InspectionVacation and Extended Shut-Down Condensate Trap InspectionDraining the Water Heater Freeze ProtectionBefore You Call For Service… Indoor Water Heater Only Outdoor Water Heater OnlyReplacement Parts Instructions For Placing a Parts OrderTemperature Setting DIP Switch Adjustment If YOU Need Service

RMTG2-53(PVN)(PVP)(XN)(XP), RTG2-53(PVN)(PVP)(XN)(XP), RUTG2-53(PVN)(PVP)(XN)(XP), PTG53-(PVN)(PVP)(XN)(XP) specifications

Rheem PTG53-(PVN)(PVP)(XN)(XP), RUTG2-53(PVN)(PVP)(XN)(XP), RTG2-53(PVN)(PVP)(XN)(XP), and RMTG2-53(PVN)(PVP)(XN)(XP) are an impressive lineup of tankless water heaters that exemplify efficiency, technology, and convenience. These models represent Rheem's commitment to innovation in water heating solutions, appealing to both residential and commercial users.

At the core of these models is their ability to deliver continuous hot water on demand, which eliminates the need for large storage tanks. The compact design allows for flexible installation options, saving valuable space and making them suitable for varied settings, including tight spaces. The units are designed to provide an endless supply of hot water, making them ideal for families with high hot water needs.

Advanced heating technology is another hallmark of the Rheem PTG53 and its counterparts. These models typically feature high-efficiency condensing design, which captures and reuses exhaust heat to enhance overall efficiency. This means users can enjoy lower energy bills while also contributing to a reduced environmental footprint.

The Rheem Tankless Water Heaters come equipped with smart functionalities, including digital displays for easy temperature settings and monitoring. Some models are compatible with Wi-Fi connectivity, enabling users to control and monitor their water heating systems remotely through a smartphone app. This feature adds an extra layer of convenience, particularly for tech-savvy homeowners seeking seamless integration into their smart home ecosystems.

Safety features are also well-considered in these models, with automatic shut-off mechanisms and overheating protection ensuring safe operation. Additionally, they boast impressive flow rates, providing sufficient hot water for multiple fixtures simultaneously, thus meeting the demands of larger households or commercial establishments.

Finally, Rheem stands behind its products with robust warranties, showcasing confidence in their durability. The PTG53, RUTG2, RTG2, and RMTG2 models are constructed to offer longevity and reliability, ensuring peace of mind for users.

In summary, Rheem's PTG53-(PVN)(PVP)(XN)(XP), RUTG2-53(PVN)(PVP)(XN)(XP), RTG2-53(PVN)(PVP)(XN)(XP), and RMTG2-53(PVN)(PVP)(XN)(XP) represent the pinnacle of tankless water heating technology. With their efficient, space-saving design, advanced features, and emphasis on safety, these units are well suited for modern living, providing endless hot water and comfort to users.
Top Page Image Contents