![](/images/new-backgrounds/1063562/6356213x1.webp)
Figure 4. — Typical Installation Drawing.
To
Gas
Supply
Manual
Gas
Thermostat
Refer to Venting section
on pages
Temperature & Pressure
Relief Valve
Hot Outlet
Valve
Thermal Expansion Tank | Cold Water | |
Inlet | ||
(if required) | ||
|
Installation
Ground Joint Union
Sediment Trap
Cap
Air Gap 6"
Gas Valve
Vacuum Relief Valve
(Not Supplied)
NOTES:
1.) The gas supply piping must be adequately supported and aligned to minimize loads (forces) on the water heater’s gas valve and burner system.
2.) Refer to local codes for installation guide- lines for the Thermal Expansion Tank (if required).
If required, install per local codes
and valve manufacturer’s
instructions.