Rheem 300 series installation instructions Patents

Page 2

Notice to Victorian Customers from the

Victorian Plumbing Industry Commission.

This water heater must be installed by a licensed person as required by

the Victorian Building Act 1993.

Only a licensed person will give you a Compliance Certificate, showing that the work complies with all the relevant standards. Only a licensed person will have insurance protecting their workmanship for 6 years. Make sure you use a licensed person to install this water heater and ask for your Compliance Certificate.

Warning: Upon completion of the installation and commissioning of the water heater, leave this guide with the householder or responsible officer. DO NOT leave this guide inside of the cover of the water heater, as it may interfere with the safe operation of the water heater or ignite when the water heater is turned on.

PATENTS

This water heater may be protected by one or more patents or registered designs.

®Registered trademark of Rheem Australia Pty Ltd.

Trademark of Rheem Australia Pty Ltd.

Image 2
Contents Owners Guide Installation Instructions Patents Contents Model Type Temperature AdjustmentAbout Your Water Heater HOW HOT should the Water BE?Safety To Turn OFF the Water HeaterHOW Long will the Water Heater LAST? To Turn on the Water HeaterDoes the Water Quality Affect the Water HEATER? Anode ProtectionPiezo Ignition HOW Your Water Heater WorksMains Pressure Pilot IgniterRegular Care Expansion Control Valve ServicingWater not HOT Enough Save a Service CallNot Enough HOT Water or no HOT Water Continuous dribble Temperature Pressure Relief Valve RunningNormal Operation Steady flows for long period often at nightHigh GAS Bills CAN’T Light the Pilot FlameWater Heater Appears to be Leaking Installation Water Heater LocationSafe Tray Mains Water SupplyTank Water Supply HOT Water DeliveryTemperature Limiting Device Circulated HOT Water Flow and Return SystemSaddling Pipe Work Reducing Heat LossesAnode Types Dimensions and Technical Data Gas DetailsTypical Installation Indoor Location Water Inlet and Outlet Connections PlumbingConnection Sizes Relief Valve GAS InletPipe Sizes Relief Valve Drain GAS Inlet Pressure CommissioningTo Fill and Turn on the Water Heater Lighting the Water Heater For Your Safety Read Before LightingSafety Information Using the gas control light the water heater as follows Lighting InstructionsTest the Water Heater After Installation AIR ShutterClose Down Procedure Draining the Water Heater This page is intentionally blank Saturation Index Water SuppliesAnode Warranty Conditions Warranty ExclusionsWarranty Rheem will