Cadet CB103T warranty Com-Pak Bath Heater, Read all instructions before using this heater

The Com-Pak Bath Heater

OWNER’S GUIDE FOR MULTI-VOLT MODELS

5/8” Height	32.07cm
12

The Com-Pak Bath Heater

10” Width

25.4cm

1/2” Depth

1.27cm

Features & Benefits

■Thermal safeguard

•High temperature manual reset: turns off heater if normal operating temperatures are exceeded

■Commercial grade steel element - painted to resist rusting

■Built-in controls

- Single pole thermostat with disabled (no heat) position - 60 minute timer overrides thermostat for instant warmth

■Powder coat paint process eliminates sharp cutting edges

■Three year extended warranty on element and motor

■Factory tested

■Multi-Volt configurations

120 or 240 Volt AC (1000 Watts) *Factory set at 240-Volts

TOOLS REQUIRED:	Utility Knife
Phillips Screwdriver	(4)	11/2" Wood Screws
Straight Screwdriver	Insulated Wire Connectors
Wire Strippers	(1)	Strain Relief Connector

Models:

CBC103TW or CB103T The Com-Pak Bathroom Heater

IMPORTANT INSTRUCTIONS

WARNING

Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock or tag the panel board door to prevent someone from turning on power while you are working on the heater. Failure to do so could result in serious electrical shock, burns, or possible death.

1.Read all instructions before using this heater.

2.Read all information labels. Verify that the electrical supply wires are the same voltage as the heater.

3.All electrical work and materials must comply with the National Electric Code (NEC), the Occupational Safety and Health Act (OSHA), and all state and local codes.

4.Connect the grounding screw provided in the wall can to the supply ground wire.

5.If you need to install a new circuit or need additional wiring information, consult a qualified electrician.

6.Protect electrical supply from kinks, sharp objects, oil, grease, hot surfaces or chemicals.

7.WARNING

Overheating or fire may occur. DO NOT install the heater in a floor, in the ceiling, below a towel bar, behind a door, or anywhere the air discharge may be blocked in any manner.

8. WARNING

Fire or explosion may occur. DO NOT install heater in any area where combustible vapors, gases, liquids, or excessive lint or dust are present.

9.WARNING

DO NOT install where heater is likely to get wet.

10. WARNING

Heater must be connected to a GFCI protected branch circuit.

11. WARNING

Burn Hazard. This heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces. Use extreme caution when any heater is used by or near children or invalids.

12. WARNING

Risk of Electrical Shock. DO NOT install the heater directly above bathtub or sink. DO NOT install in shower stall area (Manufacturer recommends a minimum 2 foot clearance).

13. WARNING

Risk of Electrical Shock. Connect grounding lead to grounding screw provided. Keep all foreign objects out of heater.

14. WARNING

Risk of Electrical Shock. Never place a switch where it can be reached from the tub or shower enclosure.

15. WARNING

Risk of Fire. Do not block heater. Heater must be kept clear of all obstructions: a minimum of 3 feet in front, 6 inches above and on both sides. Heater must be kept clean of lint, dirt and debris. (See Maintenance Instructions.)

SAVE THESE INSTRUCTIONS

www.cadetco.com Tel: 360-693-2505 P.O. Box 1675 Vancouver, WA 98668-1675