Cadet CB103T, CBC103TW warranty Troubleshooting Chart, Warranty

IMPORTANT INSTRUCTIONS

WARNING

Turn the electrical power off at the electrical panel board (circuit breaker or fuse box) and lock or tag the panel board door to prevent someone from turning on power while you are working on the heater. Failure to do so could result in serious electrical shock, burns, or possible death.

Troubleshooting Chart

CONSULT LOCAL ELECTRICAL CODES TO DETERMINE WHAT WORK MUST BE PERFORMED BY QUALIFIED ELECTRICAL SERVICE PERSONNEL.

Symptom	Problem	Solution
Breaker trips immediately	1.Incorrect supply voltage.	1. Verify that supply voltage matches the heater rating.
upon energizing heater.	2.Overloaded circuit.	2. The total amperage of all heaters on a branch circuit must not be more than
		80% of the amperage rating of the circuit breaker and supply wire ratings.
		Use a lower wattage heater, or reduce the number of heaters on the circuit.
	3.A short circuit exists in the supply	3. Shorted supply or heater wires may be accompanied by severe sparking. Inspect
	or heater wiring.	all supply and heater wiring insulation for damage. Do not reset the circuit breaker
		until all electrical shorts have been repaired.
	4.Defective circuit breaker.	4. Replace the circuit breaker.
Heater fan operates,	1.Insufficient element temperature.	1. Allow a few moments for element to reach operating temperature.
but does not discharge	2.Incorrect supply voltage.	2. Verify that supply voltage matches the heater rating.
warm air.	3.Element has failed.	3. Replace element.
Heater will not shut off.	1.Heat loss from room is greater	1. Close doors and windows. Provide additional insulation, or install a higher wattage
	than heater capacity.	heater or multiple heaters if necessary. (If your circ uit is rated for more capacity.)
	2.Thermostat is not functioning	2. Wait for the timer to time-out or turn the timer counterclockwise to `0’ (The timer
	properly.	overrides the thermostat setting). If heater continues to run, adjust thermostat
		to its lowest setting. If heater continues to run (allow two minutes for thermostat
		to respond) the thermostat requires replacement.
Heater discharges smoke	1.Dust, lint or other matter has	1. Clean heater (See “Operation & Maintenance” section for instruction s).
or emits a burnt odor.	accumulated inside heater.
Element heats for a moment	1. Defective motor or internal connection.	1. Heater or fan motor requires replacement.
without the fan turning, then	2.Fan or motor jammed.	2. Remove obstruction and press heater reset button (after allowing the unit to cool).
immediately stops heating.		Test heater operation--if reset button has been pressed (be sure to listen and feel
		for a click indicating it has been reset), but heater does not run, heater requires
		repair or replacement.
Heater does not run.	1.Thermostat is set too low, or	1. Adjust thermostat to a higher temperature until heater operates (See Problem #5
	in disabled (no heat) position.	if the problem persists).
	2.Heater has tripped the manual	2. Press the manual reset button (See “Operation & Maintenance” section for
	high-temperature reset switch.	instructions).
	3.Power not on at the circuit breaker.	3. Turn on the correct circuit breaker in the main panel.
	4.Broken or poorly connected wire(s)	4. Turn off power at circuit breaker. Check supply wire continuity and proper connection
	to heater.	to heater wires.
	5.Defective thermostat and/or timer.	5. Repair or replace the heater. The entire heater, or any of its components may be
		checked for continuity to determine the cause of any problem.
Heater continually trips	1. Dust, lint or other matter has	1. Clean heater (See “Operation & Maintenance” section for instructions).
the manual reset	accumulated inside heater.
temperature limit control.	2. Airflow is blocked.	2. Remove obstruction. Maintain a minimum distance of 6 inches from adjacent
	3. Fan or motor is ja mmed.	surfaces, 4.5 inches from the floor, and 3 feet for furniture or other objects
		placed directly in front of the heater.
		3. Remove obstruction, and press heater manual reset button (See “Operation &
	4. None of the above.	Maintenance” section for instructions) .
		4. Replace heater assembly.

Warranty

LIMITED ONE-YEAR WARRANTY: Cadet will repair or replace any Cadet product, including thermostats, found to be defective within one year after the date of purchase.

Extended Product Warranty

LIMITED THREE-YEAR WARRANTY: Cadet will repair or replace any Com-Pak Bathroom Heater (CB) series element or motor found to be defective or malfunctioning from first date of purchase through the third year.

These warranties do not apply:

1.Damage occurs to the product through improper installation or incorrect supply voltage;

2.Damage occurs to the product through improper maintenance, misuse, abuse, accident, or alteration;

3.The product is serviced by anyone other than Cadet;

4.If the date of manufacture of the product cannot be determined;

5.If the product is damaged during shipping through no fault of Cadet.

6.CADET’S WARRANTY IS LIMITED TO REPAIR OR REPLACEMENT AS SET OUT HEREIN. CADET SHALL NOT BE LIABLE FOR DAMAGES SUCH AS PROPERTY DAMAGE OR FOR CONSEQUENTIAL DAMAGES AND/OR INCIDENTAL EXPENSES RESULTING FROM BREACH OF THESE WRITTEN WARRANTIES OR ANY EXPRESS OR IMPLIED WARRANTY.

7.IN THE EVENT CADET ELECTS TO REPLACE ANY PART OF YOUR CADET PRODUCT, THE REPLACEMENT PARTS ARE SUBJEC T TO THE SAME

WARRANTIES AS THE PRODUCT. THE INSTALLATION OF REPLACEMENT PARTS DOES NOT MODIFY OR EXTEND THE UNDERLYING WARRANTIES. REPLACEMENT OR REPAIR OF ANY CADET PRODUCT OR PART DOES NOT CREATE ANY NEW WARRANTIES.

8.These warranties give you specific legal rights, and you may also have other rights which vary from state to state. Cadet neither assumes, nor authorizes anyone to assume for it, any ot her obligation or liability in connection with its products other than as set out herein.

If you believe your Cadet product is defective, please contact Cadet Manufacturing Co . at 360 - 693 - 2505, during the warranty period, for instructions on how to have the repair or replacement processed. Warranty claims made after the warranty period has expired will be denied. Products returned without authorization will be refused.

Parts and Service

Visit http://support.cadetco.com for information on where to obtain parts and service.

Reduce-Reuse-Recycle

This product is made primarily of recyclable materials. You can reduce your carbon footprint by recycling this product at the end of its useful life. Contact your local recycling support center for further recycling instructions.

©2009 Cadet Manufacturing Co. Printed in U.S.A. Rev. 7/11 #720050 5