GE AP13787 Operating the water heater, Safety Precautions, Operating Procedure

Page 23

Operating the water heater.

CAUTION: Hydrogen gas can be produced in a hot water system served by this water heater that has not been used for a long period of time (generally two weeks or more). HYDROGEN GAS IS EXTREMELY FLAMMABLE!! To dissipate such gas and to reduce risk of injury, it is recommended that the hot water faucet be opened for several minutes at the kitchen sink before using any electrical appliance connected to the hot water system. If hydrogen is present, there will be an unusual sound such as air escaping through the pipe as the water begins to flow. Do not smoke or use an open flame near the faucet at the time it is open.

Safety Instructions

Safety Precautions

Do turn off manual gas shut-off valve if water heater has been subjected to over heating, fire, flood, physical damage or if the gas supply fails

to shut off.

Do Not turn on water heater unless it is completely filled with water.

Do Not turn on water heater if cold water supply shut-off valve is closed.

Do Not allow combustible materials such as newspaper, rags or mops to accumulate near water heater.

Do Not store or use gasoline or other flammable vapors and liquids, such as adhesives or paint thinner, in vicinity of this or any other appliance. If such flammables must be used, open doors and windows for ventilation, and all gas burning appliances in the vicinity should be shut off including their pilot burners, to avoid vapors lighting.

NOTICE: Flammable vapors can be drawn by air currents from surrounding areas to the water heater.

If there is any difficulty in understanding or following the Operating Instructions or the Care and Cleaning section, it is recommended that a qualified person or serviceman perform the work.

Installation Instructions Operating

Operating Procedure

This heater is equipped with a spark ignitor to light the main burner. There is no pilot light to be lit, but on initial start-up, it is recommended that the outer door be removed (leave inner door in place for safety) to determine if the spark ignitor and main burner are operating properly.

To put the heater into operation it is only necessary to turn the main manual gas valve to the “ON” position, plug the power cord in and make sure the “ON/OFF” switch located on the blower assembly is in the “ON” position. Within 90 seconds the spark ignitor

should spark, then the gas valve should open and the main burner ignite. After the main burner ignites, replace the outer door. If no main burner flame is established, the gas control will go through three trials for ignition before going into a lock-out. A warning light will alert the user of this lock-out condition. If this happens, refer to “Troubleshooting Guide.”

TO SHUT OFF WATER HEATER – Turn switch on the blower assembly to the “OFF” position and turn the main manual gas shut- off valve to the “OFF” position.

Instructions Care and Cleaning

!DANGER: Hotter water increases the Potential for Hot Water SCALDS. Households with small children, disabled, or elderly persons may require a 120°F or lower gas control (thermostat) setting to prevent contact with HOT water.

Water Temperature Setting

The temperature of the water in the water heater can be regulated by setting the temperature dial on the front of the gas control (thermostat).

Safety and energy conservation are factors to be considered when selecting the water temperature setting of the water heater’s gas control (thermostat(s)). The lower the temperature setting, the greater the savings in energy and operating costs.

To comply with safety regulations, the gas control (thermostat) was set at its lowest setting before the water heater was shipped from the factory. The recommended starting point temperature is 120°F.

Water temperatures above 125°F

can cause severe burns or death from scalding. Be sure to read and follow the warnings outlined in this manual and on the label located on the water heater near the gas control thermostat.

Mixing valves are available for reducing point of use water temperature by mixing hot and cold water in branch water lines. Contact a licensed plumber or the local plumbing authority for further information. (See page 4 for more details.)

The chart below may be used as a guide in determining the proper water temperature for your home.

23

Troubleshooting Tips Customer Service

Image 23
Contents Do not try to light any appliance With Installation Instructions for the InstallerResidential 40 and 50 Gallon Rheem Manufacturing CompanyFor Your Records R N I N G For Hot Water Scalds Water Temperature Time To Produce a Serious Burn120F 90F 160F Vacation Setting Safety Instructions Installation Customer Service Troubleshooting Tips Care and CleaningFront Sides Rear Top Installing the water heaterLocation Corrosive Atmospheres Customer ServiceInspect Shipment Combustion and Ventilation AirWater Supply Connections Typical InstallationCleaning Troubleshooting Tips Customer Service Thermal ExpansionCondensation Care and Cleaning OperatingRelief Valve To Fill the Water HeaterGas Supply Leak TestingPressure Testing the Gas Supply System Troubleshooting Tips Customer ServiceVenting Blower Assembly InstallationIf not factory installed Customer Service TroubleshootingVenting information for 3 Vents Maximum and Minimum Vent LengthsVenting information for 2 Vents Operating Care and CleaningHorizontal Vent Terminal Location Additional ConsiderationsVertical Vent Termination Location Horizontal Vent InstallationVertical Vent Installation Instructions Care and CleaningCementing Joints Cleaner-Primer and Medium Body Solvent CementDraining the Condensate Service WiringInsulation Blankets Heat Trap Hot and Cold Pipe Insulation InstallationDuring Installation of this water heater Water Supply Installation ChecklistWater Heater Location Combination Potable and Space Heating Application Care and Cleaning Troubleshooting TipsLighting the water heater Troubleshooting Tips Customer Service Safety PrecautionsOperating Procedure Installation Instructions Operating120F Water Temperature Setting…Water Temperature Draining the Water Heater Routine Preventative MaintenanceInstructions Installation Instructions SafetyBurner Inspection Installation Instructions SafetyHousekeeping Venting System InspectionAnode Rod Vacation and Extended Shut-DownBefore You Call For Service… Noise or draining Rumbling noiseRelief valve Producing poppingSecond Seconds Gas Valve LED Error CodesInstructions For Placing a Parts Order Replacement PartsBurner Assembly Kit Operating Instructions Care and CleaningInstallation Instructions Troubleshooting Tips If YOU Need Service Please place in envelope and mail to Consumer Product Ownership Registration If you require service, call

AP13787 specifications

The GE AP13787 is a smart and innovative appliance that has quickly gained attention for its advanced features and modern technologies. This product exemplifies GE's commitment to providing consumers with high-quality and efficient home solutions. The GE AP13787 stands out in the market, particularly due to its combination of functionality, energy efficiency, and user-friendly design.

One of the primary features of the GE AP13787 is its cutting-edge smart technology, which integrates seamlessly with smart home systems. This appliance is equipped with Wi-Fi connectivity, allowing users to control it remotely through a smartphone application. This capability enhances convenience, as consumers can monitor and adjust settings from anywhere, whether they are at home or on the go. The smart diagnosis feature also adds value, enabling users to troubleshoot potential issues quickly, minimizing downtime, and ensuring the appliance operates optimally.

In addition to its smart capabilities, the GE AP13787 boasts energy-efficient performance, an increasingly vital consideration for eco-conscious consumers. The appliance is designed to reduce energy consumption without sacrificing performance, helping users save on utility bills while also promoting sustainability. Its Energy Star certification is a testament to its efficiency, reflecting GE’s emphasis on responsible manufacturing and environmental stewardship.

Another notable characteristic of the GE AP13787 is its spacious and thoughtful design. It features ample storage and organization options, enabling users to maximize their kitchen space effectively. With adjustable shelves, clear bins, and easy-access compartments, finding and storing food items becomes a hassle-free experience.

Moreover, the GE AP13787 includes advanced cooling technologies that ensure optimal food preservation. Its Precision Temperature Management system keeps food at ideal temperatures, while the advanced air circulation technology promotes even cooling throughout the appliance. This feature is especially beneficial for maintaining the quality of perishables, extending their shelf life.

Overall, the GE AP13787 delivers a blend of modern technology, energy efficiency, and practical design. It is a perfect addition to any contemporary kitchen, catering to the demands of today’s consumers who seek convenience and quality. As the market for smart home appliances continues to grow, products like the GE AP13787 illustrate how innovation can enhance everyday living while being mindful of environmental impact.