Desa VML27PR installation manual Lighting Instructions, Control Knob and Ignitor Button Location

Page 15

OPERATING HEATER

Lighting Instructions

15

OPERATING HEATER

Continued

LIGHTING

INSTRUCTIONS

WARNING:

•If fireplace has glass doors, never operate this heater with glass doors closed. If you operate heater with doors closed, heat buildup inside fire- place will cause glass to burst. Make sure there are no obstructions across openings of fireplace.

•You must operate this heater with a fireplace screen in place. Make sure fireplace screen is closed before running heater.

NOTICE: During initial operation of new heater, burn- ing logs will give off a paper-burning smell. Open damper or window to vent smell. This will only last a few hours.

Note: Homeowners generally prefer to operate their heater with the chimney damper closed. This will put all the heat into the room. However, there may be times you will desire the full flames of the HI heat setting but will find the heat output excessive. You can open the chimney damper (if you have one) fully or partially to release some of the heat.

WARNING: Damper handle will be hot if heater has been running.

WARNING: Burner will come on automatically within one minute when control valve is in the ON position after pilot is lit.

7.With control knob pressed in, press and release ignitor but- ton. This will light pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor button until pilot lights.

Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure on page 16.

8.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

•If control knob does not pop out when released, contact a qualified service person or gas supplier for repairs. Note: If pilot goes out, repeat steps 4 through 8.

9.Slightly push in and turn control knob counterclockwise to the ON position.

10.Set flame adjustment knob to any level between HI and LO.

11.Replace control cover log (see Installing Logs, pages 13 and 14).

CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve.

Control

Cover Log

IH

O

N

OT

1.STOP! Read the safety information, column 2 on page 14.

2.Make sure equipment shutoff valve is fully open.

3.Remove control cover log (see Figure 28).

4.Press in and turn control knob clockwise to the OFF position.

5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low “B” in the safety information, column 2 on page 14. If you don’t smell gas, go to the next step.

6.Press in and turn control knob counterclockwise to the PILOT position. Press in control knob for five (5) seconds (see Figure 28).

Note: You may be running this heater for the first time after hooking up to gas supply. If so, the control knob may need to be pressed in for 30 seconds or more. This will al- low air to bleed from the gas system.

Ignitor Button

Flame

Control

 

Adjustment

 

Knob

 

Knob

 

 

Figure 28 - Control Knob and Ignitor Button Location

Pilot Burner

Pilot Burner

Ignitor

Ignitor

Electrode

 

 

Electrode

 

 

Figure 29 - Natural Gas Pilot Figure 30 - Propane/LP Gas Pilot

For more information, visit www.desatech.com

111115-01D

Page 14 Page 16
Image 15
Page 14 Page 16
Contents What to do if YOU Smell GAS Remote Control Ready Model Patent PendingFLAME-MAX VML27NR VML27PRSafety Information Table of ContentsLocal Codes Product IdentificationAIR for Combustion and Ventilation Product FeaturesRemote Control Accessories UnpackingDetermining FRESH-AIR Flow for Heater Location Confined and Unconfined SpaceDetermining if You Have a Confined or Uncon- fined Space Ventilation Air From Outdoors InstallationVentilation AIR Ventilation Air From Inside BuildingCheck GAS Type Installation and ClearancesMinimum Fireplace Clearance to Combustible Materials LOG Sizing RequirementsDetermining Minimum Mantel Clearance Determining Minimum Mantel Clearance When using a HoodMantel Clearances Minimum Noncombustible Material ClearancesFloor Clearances Installing Damper Clamp Accessory for Vented OperationInstalling Remote Receiver Installing Heater Base AssemblyInstalling Optional Remote Control Accessories Installation Items NeededInstalling 9-Volt Battery in Receiver Connecting to GAS SupplyChecking GAS Connections Pressure Testing Gas Supply Piping SystemInstalling Logs Pressure Testing Heater Gas ConnectionsProperty damage or personal injury Operating Heater For Your Safety Read Before LightingControl Knob and Ignitor Button Location Lighting InstructionsON/OFF Series Model Ghrcb Manual Lighting ProcedureTo Turn OFF GAS To Appliance Optional HAND-HELD Remote OperationMain Burner Inspecting BurnersPilot Flame Pattern Burner Primary AIR HolesLogs Cleaning MaintenanceWiring Diagram Cleaning Burner Injector Holder and Pilot AIR Inlet HoleObserved Problem Possible Cause TroubleshootingObserved Problem Possible Cause Remedy Top Gas leak. See Warning statement atModels VML27PR VML27NR Illustrated Parts BreakdownKEY Part Number VML27PR VML27NR Description QTY Parts ListParts Under Warranty SpecificationsService Hints Technical Service Replacement PartsOwners Registration Form Postage Required Receiver and HAND-HELD Remote CON Trol KIT Ghrcb WALL-MOUNT Thermostat Switch GWMT1WALL-MOUNT ON/OFF Switch GWMS2 Cleaning KIT GCKWarranty Information

VML27PR specifications

Desa VML27PR is a cutting-edge development that represents a significant leap forward in efficient living and sustainable technology. This modern residential complex is designed with both aesthetics and functionality in mind, making it a prime choice for contemporary urban dwellers.

One of the standout features of Desa VML27PR is its commitment to energy efficiency. The buildings are equipped with solar panels that harness renewable energy, significantly reducing reliance on non-renewable power sources. This integration not only lowers utility bills for residents but also contributes to a lower carbon footprint, aligning with global sustainable development goals.

The architecture of Desa VML27PR is marked by its contemporary design, featuring open floor plans and large windows that maximize natural light and ventilation. The use of eco-friendly construction materials further enhances the sustainability aspect, ensuring that the development minimizes its impact on the environment while providing a comfortable living space.

Safety and security are of paramount importance in Desa VML27PR. The complex is equipped with state-of-the-art security systems, including video surveillance and controlled access points, giving residents peace of mind. Additionally, the premises are well-lit and feature landscaped green spaces, promoting a sense of community while ensuring a safe environment for families.

Another significant characteristic of Desa VML27PR is its emphasis on smart technology integration. Homes are equipped with smart appliances and systems that allow residents to control lighting, heating, and security from their mobile devices. This not only enhances convenience but also promotes energy savings by enabling users to monitor and manage their usage effectively.

Desa VML27PR also boasts a variety of communal facilities designed to foster community engagement. These include recreational areas, fitness centers, and coworking spaces that encourage interaction among residents, making it an ideal place for those seeking a vibrant social life.

In conclusion, Desa VML27PR exemplifies the future of urban living, combining sustainability, modern design, advanced technology, and community-focused amenities. It stands as a model for future residential developments, showcasing how contemporary living can harmoniously coexist with environmental responsibility and community engagement. Whether seeking a home for a growing family or a sophisticated living space for professionals, Desa VML27PR is equipped to meet diverse needs, making it a premier choice in today’s real estate market.
Top Page Image Contents