16
OPERATING HEATER
To Turn Off Gas To Appliance
Manual Lighting Procedure
Optional
OPERATING HEATER
Continued
TO TURN OFF GAS
TO APPLIANCE
Shutting Off Heater
1.Remove control cover log (see Figure 28, page 15).
2.Turn control knob clockwise to the OFF position.
3.If Using Optional
4.Replace control cover log (or all logs if removed in step 3). See Installing Logs, pages 13 and 14.
Shutting Off Burner Only (pilot stays lit)
You may shut off the burner and keep the pilot lit by doing one of the following:
1.Remove control cover log (see Figure 28, page 15). Turn
control knob clockwise to the PILOT position. Re- place control cover log.
1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjustment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position (see Figure 52). Note: The burner may light if
IMPORTANT: Do not leave the selector switch in the RE- MOTE or ON position when the pilot is not lit. This will drain the battery.
Piezo Ignitor | Flame Adjustment | |
Knob | ||
|
IH |
| F | PIL |
ON |
| O | |
| O |
| T |
OFF |
| O | |
|
| N | |
REMOTE |
|
|
|
LO |
|
|
|
Control Knob in
Selector Switch in REMOTE Position On Position
(Optional
2.If Using Optional
WARNING: Make sure remote sensor selector switch is in the OFF position when you are away from home for long periods of time. Follow step 3 under Shutting Off Heater.
MANUAL LIGHTING
PROCEDURE
1.Follow steps 1 through 6 under Lighting Instructions, page 15.
2.Depress control knob and light pilot with match.
3.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob. Now follow steps 9 through 11, page 15.
OPTIONAL HAND-HELD
REMOTE OPERATION
Note: All remote control accessories must be purchased sepa- rately (see Accessories, page 27). Follow instructions included with the remote control.
Figure 31- Setting the Selector Switch, Control Knob, and Flame Adjustment Knob for Hand-Held Remote Operation
ON/OFF SERIES (MODEL GHRCB)
Hold the control button on the
TO LOCK press both buttons on
TO UNLOCK press both buttons together on
Control Button
Turns Burners
On and Off
NOTICE: You must light the pilot before using the
Figure 32 - On/Off Hand-Held Remote Control Unit (GHRCB)
THERMOSTAT SERIES (MODEL GHRCTB)
The
For morevisit www..com