14
INSTALLATION
Installing Logs (Cont.)
OPERATION
For Your Safety Read Before Lighting
INSTALLATION
Continued
2.Facing front of unit, place left rear log (#2) onto the two pins on left rear of base log (see Figure 25).
3.Position left front log (#3) onto two pins on left front and middle of base log (see Figure 25).
4.Place right rear log (#4) onto two pins on right rear of base log (see Figure 26).
5.Place right front log onto two pins on right front of base log (see Figure 26).
6.Place control cover log onto two pins in front right section of base log. Be sure control cover log seats well into cutout sec- tion of base log.
7.Place lava rock around base of heater.
Control Cover 
Log (#6)
Figure 27 - Control Cover Log (#6) Placement
Burner Ports
Logs
OPERATING HEATER
FOR YOUR SAFETY READ
BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing prop- erty damage, personal injury or loss of life.
Figure 24 - Installing Log set (Top View)
Left Rear Log | Left Front | Right Rear | |
Log (#4) | |||
(#2) | |||
Log (#3) |
| ||
|
|
Right Front
Log (#5)
Figure 25 - Installing Left Top | Figure 26 - Installing Right |
Logs (#2 and #3) | Top Logs (#4 and #5) |
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electric switch; do not use any phone in your building.
•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
For more
visit www.
.com
