Installation
Continued
4.Check all joints of gas supply piping system. Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.
5.Correct all leaks at once.
6.Reconnect heater and equipment shutoff valve to gas supply. Check reconnected fit- tings for leaks.
Test Pressures Equal To or Less Than
1/2 PSIG (3.5 kPa)
1. Close equipment shutoff valve (see Figure 13).
2. Pressurize supply piping system by either opening propane/LP supply tank valve for propane/LP gas or opening main gas valve located on or near gas meter for natural gas or using compressed air.
3. Check all joints from gas meter to equipment shutoff valve for natural gas or propane/LP sup- ply to equipment shutoff valve for propane/LP (see Figure 14 or 15). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.
4. Correct all leaks at once.
Pressure Testing Heater Gas
Connections
1. Open equipment shutoff valve (see Figure 13).
2. Open main gas valve located on or near gas meter for natural gas or open propane/LP supply tank valve.
3. Make sure control knob of heater is in the OFF position.
Open
Equipment
Shutoff Valve 
Closed
Figure 13 - Equipment Shutoff Valve
Equipment Shutoff Valve
Gas Meter
Control Valve
Location
Figure 14 - Checking Gas Joints for
Natural Gas
4.Check all joints from equipment shutoff valve to control valve (see Figure 14 or 15). Apply noncorrosive leak detection fluid to all joints. Bubbles forming show a leak.
5.Correct all leaks at once.
6.Light heater (see Operating Heater, page 15). Check all other internal joints for leaks.
7.Turn off heater (see To Turn Off Gas to Appli- ance, page 18).
Propane/LP | Equipment Shutoff Valve |
Supply Tank |
|
Control Valve Location |
Figure 15 - Checking Gas Joints for
Propane/LP Gas
Adding Embers, Lava rock and Decorative logs
The effect of glowing embers is created by placing ember material on the front burner.
1.Make sure the heater is OFF and has cooled if it has been running.
2.Gently remove embers from the bag using gloves or tweezers (recommended to prevent skin irritation). Separate the pieces.
3.Place ember pieces, one at a time, over ports on flat burner (see Figure 16). Do NOT place ember material anywhere else on the unit.
Use only ember material supplied with unit (12 one inch square pieces). Excessive ember mate- rial may produce carbon monoxide or soot.
Place Glowing Embers on Burner Ports 
Place Lava Rock and
Small Decorative
Logs in Front of
Burner
Figure 16 - Placement of Embers and
Lava Rock
14 | www.desatech.com |