Operating Heater
Continued
6. | Press the buttons | and | at the same | |
| time. A short acoustic signal confirms the | |||
| start sequence has begun. |
| ||
| Further short acoustic signals (0.2 sec., 1 Hz) | |||
| indicate the ignition process until it is com- | |||
| pleted and main gas flows. If pilot is already | |||
| lit, motor will turn on (max. flame height) | |||
| while buttons are pressed down. If pilot does | |||
| not light, see Troubleshooting, page 21. | |||
7. | Press | to turn on main burner and in- | ||
| crease flame height. Press | to decrease | ||
| flame height and shut off main burner. | |||
8.Short tapping of either button allows incre- mental change in flame height.
9.Press OFF button to switch off main gas and pilot gas.
Functions of
REMOTE CONTROL
Battery
• After the charged battery has been correctly installed, the remote hand set is ready for operations.
• Remove the battery if the remote handset will not be used more than one year.
Changing The Code
The control is radio frequency operated. A code (chosen from among 4,000 available codes) is preset for all valves, but can be changed if re- quired (15 additional codes available). Change DIP switch position. (The DIP switch is located inside the hand held control at the top of the battery compartment.) Then press the receiver's reset button on the bottom of the receiver module until you hear a second (longer) signal. When pressing the button on the remote handset in the following 20 sec., the receiver learns the new code.
SET
STAND
OFFBY
Figure 17 - Control Panel for Hand-Held Remote
Shut-off Procedure
To save battery power; press to turn main gas to pilot gas. Press OFF button to shut off the device including pilot flame. The device can be shut off with ON/OFF switch, thus disabling the remote hand set.
Setting The Display ( °C/24h and °F /12h)
Press and hold OFF and until display changes from °F (and 12 hour clock) to °C (and 24 hour clock) or vice versa.
Setting The Time |
|
|
• After connecting the battery or by simulta- | ||
neously pressing | and | the display will |
start to flash. You are in the set mode. | ||
• From SET mode press | to set the hour and | |
to set the minute. |
| |
•Wait or press OFF to return to the manual mode.
Battery Replacement
Remote handset battery needs to be changed when LED is dim. Battery life expectancy is 2 to 3 years. Replacement is recommended at the beginning of heating season. Battery needs to be changed when acoustic error message appears during ignition (see Identifying Error Signals from Receiver on page 24).
Changing Mode of Operation
• Press the SET button quickly to change the mode of operation in the following order:
MAN, |
|
| TEMP, TEMP, TIMER. |
|
| ||
• Manual | flame height adjustment (MAN ap- | ||
pears on display): Press to turn on the fire | |||
(main burner) or to increase flame height. | |||
Press |
| to decrease flame or to go down | |
to pilot only. The receiver acknowledges the transmission with an acoustic signal.
•The day time temperature mode (
TEMP ap- pears on display): The sensor in the transmitter measures room temperature. The controller compares the room temperature with set tem- perature and sends a signal to the receiver to turn the gas valve motor up or down, to adjust the flame height accordingly.
•The nighttime setback temperature ( TEMP appears on display): The sensor in the transmitter measures the temperature and adjusts it according to the nighttime setback temperature. There is a bigger temperature differential during this cycle.
16 | www.desatech.com |