Cleaning and
Maintenance
Continued
1.Remove two screws from back of unit that attach main log assembly to base assembly
(see Figure 24).
2 . Remove screws from left and right side of front log assembly to remove from base as-
5.Check the injector holder located at the end of the burner tube again. Remove any large particles of dust, dirt, lint or pet hair with a soft cloth or vacuum cleaner nozzle.
6.Blow air into the primary air holes on the injector holder.
7.In case any large clumps of dust have now been pushed into the burner repeat steps 5 and 6.
sembly (see Figure 24).
3.Inspect burner and primary air inlet holes on injector holder of each burner for dust and dirt (see Figures 24 and 25).
4.Blow air through the ports/slots and holes in the burner.
Injector Holder
Burner Tube
Main Log 
Assembly
Injector | Primary Air | |
Inlet Opening | ||
|
Figure 25 - Injector Holder on Front
Burner Tube
Cleaning | Front Log | |
Assembly | ||
Access | ||
| ||
| Screws |
Base
Assembly
Figure 24 - Removing Front Log to Clean
Front Burner
20 | www.desatech.com |