Desa RH10PT Connecting to Portable Cylinder GAS Supply, Connecting to Permanent

Page 8

INSTALLATION

Continued

CONNECTING TO PORTABLE CYLINDER GAS SUPPLY

WARNING: Review and un- derstand the warnings in the Safety Information section, page

3.They are needed to safely op- erate this heater. Follow all local codes when using this heater.

WARNING: Test all gas piping and connections for leaks after installation or servicing. Never use an open flame to check for a leak. Apply a noncorrosive leak detection fluid to all joints. Bubbles forming show a leak. Correct all leaks at once.

WARNING: Use pipe joint sealant that is resistant to liquid petroleum (LP) gas.

Never bring a refillable pro- pane/LP cylinder indoors. A fire or explosion can occur causing property damage, serious injury or death.

IMPORTANT: You must use a propane/LP gas supply cylinder that is compatible with the connec- tion device provided with the hose and regulator.

1.Remove 90° gas fitting from hardware bag.

2.Apply pipe joint sealant lightly to male NPT threads (see Figure 10). This will prevent excess sealant from going into pipe. Excess sealant in pipe could result in clogged heater valves.

3.Hold gas pressure regulator with wrench when connecting the 90° gas fitting. Do not over tighten connection to regulator. The regulator body could be damaged.

4.Provide propane/LP supply system (see Pro- pane/LP Supply, page 5).

5.Connect fuel gas fitting on hose/regulator assem- bly to propane/LP tank(s). Turn fuel gas fitting counterclockwise into threads on tank. Tighten firmly using a wrench. IMPORTANT: Position regulator so that hose leaving the regulator is in a horizontal position (see Figure 11). This

places the regulator vent in the proper position to protect it from the weather.

6.Connect hose to heater inlet. Tighten firmly using a wrench. You must use the regulator supplied with heater.

7.Open propane/LP supply valve on propane/LP tank(s) slowly. Note: If not opened slowly, excess-flow check valve on propane/LP tank may stop gas flow. If this happens, close pro- pane/LP supply valve and open again slowly.

8.Check all connections for leaks. Apply a noncor- rosive leak detection fluid to gas joints. Bubbles forming show a leak that must be corrected.

9.Close propane/LP supply valve.

 

 

Pressure

 

 

Regulator

 

 

Heater

 

 

Cabinet

 

 

Apply Sealant To

 

 

This End Only

Elbow

 

Hose Fitting

 

 

Hose To

 

Regulator

 

Figure 10 - Gas Connection

Propane/LP

Regulator

 

Hose To

Supply Valve

 

 

Heater

 

 

Propane/LP

 

Fuel Gas

Tank

 

 

Fitting

 

 

Figure 11 - Regulator Position

CONNECTING TO PERMANENT

GAS SUPPLY

 

 

WARNING: This appliance

requires a 3/8" NPT (National

Pipe Thread) inlet connection to

the pressure regulator.

WARNING: A qualified ser-

vice person must connect heater

to gas supply. Follow all local

codes.

 

 

8

www.desatech.com

110373-01E

Image 8
Contents What to do if YOU Smell GAS Table of Contents Safety Information Do not USE this Heater insideLocal Codes UnpackingProduct Features InstallationProduct Identification PROPANE/LP SupplyInstalling Heater to Wall Thermostat Sensing BulbPlacing Heater On Mounting Screws Installing Bottom Mounting ScrewRemoving Front Panel Of Heater Connecting to Portable Cylinder GAS Supply Connecting to PermanentGAS Supply Remove 90 gas fitting from hardware bagInstallation Items From your dealer. See Accessories,If installing to a fixed fuel piping system, Dealer. See Accessories,Test Pressures Equal To or Less Than 1/2 Psig 3.5 kPa Checking GAS Connections for Permanent GAS SupplyTest Pressures In Excess Of 1/2 Psig 3.5 kPa For Your Safety Read Before Lighting Operating HeaterLighting Instructions Ignitor Button Control KnobInspecting Heater Cleaning Maintenance CabinetTroubleshooting Observed Problem Possible Cause RemedyDelayed ignition of burner Manifold pressure is too low Burner orifice is clogged Clean burner see CleaningWhen burner is lit Est position when burner is Or shut off Qualified service personGas leak. See Warning Statement aboveSpecifications Service HintsTechnical Service Service Publications AccessoriesIllustrated Parts Breakdown Parts List NJF-8CWarranty Information Keep this Warranty

RH10PT specifications

Desa RH10PT is a cutting-edge development that showcases the latest advancements in sustainable living and smart technology integration. Situated in an eco-friendly environment, this residential project boasts an impressive array of features designed to enhance the quality of life for its residents while minimizing environmental impact.

One of the main characteristics of Desa RH10PT is its commitment to sustainability. The development incorporates green building practices, utilizing eco-friendly materials and adhering to energy-efficient standards. Solar panels are installed on rooftops, providing residents with renewable energy that reduces electricity costs and carbon footprints. Rainwater harvesting systems are also integrated, allowing for the collection and reuse of water for irrigation and other non-potable uses.

In addition to its sustainability initiatives, Desa RH10PT is designed with smart technology in mind. The residential units are equipped with advanced home automation systems that enable residents to control lighting, heating, and security features remotely via smartphones or tablets. This technology not only enhances convenience but also improves energy management by allowing occupants to monitor and adjust their energy consumption in real time.

Safety is another paramount aspect of Desa RH10PT. The community is secured with state-of-the-art surveillance systems and gated entry points, ensuring a safe living environment for families. Additionally, the design of the neighborhood encourages a sense of community while providing ample green spaces, parks, and recreational facilities. This thoughtful layout promotes outdoor activities and fosters social interactions among residents.

Furthermore, Desa RH10PT emphasizes connectivity and accessibility. The development is strategically located near major transportation hubs, educational institutions, and healthcare facilities, making it an attractive option for families and professionals alike. The integration of walking and biking paths throughout the community encourages healthy lifestyles and reduces reliance on vehicles.

In conclusion, Desa RH10PT represents a modern approach to housing that harmonizes sustainability, technology, and community living. With its innovative features, eco-friendly practices, and smart home technologies, this development is poised to set a benchmark for future residential projects, ultimately shaping the way we think about urban living. Residents are afforded the opportunity to embrace a lifestyle that is not only comfortable but also responsible and forward-thinking, positioning Desa RH10PT as a model for sustainable, modern living in today's world.