OPERATING HEATER
For Your Safety Read Before Lighting (Cont.) Lighting Instructions
19
OPERATING HEATER
Continued
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service techni- cian or gas supplier. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING
INSTRUCTIONS
WARNING
•If fireplace has glass doors, never operate this heater with glass doors closed. If you operate heater with doors closed, heat buildup inside fire- place will cause glass to burst. Make sure there are no obxtructions across openings of fireplace.
•You must operate this heater with a fireplace screen in place. Make sure fireplace screen is closed before running heater.
NOTICE: During initial operation of new heater, burn- ing logs will give off a
Note: Home owners generally prefer to operate their heater with the chimney damper closed. This will put all the heat into the room. However, there may be times you will desire the full flames of the HI heat setting but will find the heat output excessive. You can open the chimney damper (if you have one) fully or partially to release some of the heat.
WARNING: Damper handle will be hot if heater has been running.
1.STOP! Read the safety information, starting in column 2, page 18.
2.Make sure equipment shutoff valve is fully open.
3.Set selector switch in the OFF position.
4.Press in and turn control knob clockwise 
to the OFF position (see Figure 28).
WARNING: Burners will come on automatically within one minute when the selector switch is in the ON position after the pilot is lit.
5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Fol- low “B” in the safety information, starting in column 2, page 18. If you don’t smell gas, go to the next step.
6.Press in and turn control knob counterclockwise 
to the PILOT position. Press in control knob for five (5) seconds (see Figure 28).
Note: You may be running this heater for the first time after hooking up to gas supply. If so, the control knob may need to be pressed in for 30 seconds or less. This will allow air to bleed from the gas system.
7.With control knob pressed in, press and release ignitor button. This will light pilot. The pilot is attached to the front burner. If needed, keep pressing ignitor button un- til pilot lights.
Note: If pilot does not stay lit, contact a qualified service person or gas supplier for repairs. Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 20.
Control Knob
O | O | L |
IL T | O | |
P |
| |
F | N |
|
|
| |
F |
|
|
O |
|
|
| HI | AUTO |
|
| OFF |
|
| ON |
Ignitor Button | Flame | Selector Switch | |
Adjustment | |||
in OFF Position | |||
| Knob | ||
|
|
Figure 28 - Control Knob and Ignitor Button Location
For more
visit www.
.com
