Internet Version for Reference Only | BRADFORD WHITE | |
| Page 2 | |
|
|
|
|
|
|
| TABLE OF CONTENTS |
|
SECTION 1. |
| |
General Information |
| |
1.1 | Introduction | 3 |
1.2 | Heater Identification | 3 |
1.3 | Flow Requirements | 3 |
1.4 | Water Chemistry | 4 |
SECTION 2. |
| |
Installation |
| |
2.1 | Heater Placement | 4 |
2.2 | Installation of Indoor Heaters | 4 |
2.2.1 | Combustion Air Supply | 4 |
2.2.2 | Venting | 6 |
2.3 | Installation of Outdoor Heaters | 7 |
2.4 | Gas Supply and Piping | 7 |
2.5 | Electrical Wiring | 8 |
2.6 | Water Piping of System | 8 |
2.7 | Water Expansion | 9 |
2.8 | Pump Performance and Installation | 9 |
2.9 | Water Pressure | 10 |
2.10 | Tank Installation | 10 |
2.11 | 11 |
SECTION 3. |
| |
Operation |
| |
3.1 | Controls - General | 14 |
3.1.1 | Electronic Ignition Control | 14 |
3.1.2 | Operating Control | 14 |
3.1.3 | High Limit Controls | 14 |
3.1.4 | Flow Switch | 14 |
3.1.5 | Low Water | 14 |
3.2 | Initial | 14 |
3.3 | To Start Up System | 15 |
3.3.1 | Start Up Heater | 15 |
3.3.2To Set Temperature and High Limit
Control | 15 |
3.4 To Turn Off Heater | 16 |
3.5 To Shut Down System | 16 |
SECTION 4. |
|
Maintenance |
|
..................................................................... | 16 |
SECTION 5. |
|
Troubleshooting and Analysis of |
|
Service Problems |
|
..................................................................... | 17 |