Bradford-White Corp 500-1825 warranty Installation of Outdoor Heaters, Gas Supply and Piping

Internet Version for Reference Only

B4 Volume Water Heater Page 7

3.Avoid using long horizontal runs of the vent pipe, and too many 90° elbows, reductions or restrictions. Horizontal runs should have at least a 1/4" rise per foot in the direction of flow. A vent connector should be supported for the design and weight of the material used to maintain clearances and prevent physical damage and separation of joints.

4.Avoid ending heater vents near air conditioning or air supply fans. The fans can pick up exhaust flue products from the heater and return them inside the building, creating a possible health hazard. A minimum of 4 feet horizontal distance must be maintained from electrical meters, gas meters, and relief equipment.

5.Always use double-wall or insulated vent pipe (Type B or equivalent). In cold weather, uninsulated outside vents can chill the rising flue products, blocking the natural draft action of the venting system. This can create a health hazard by spilling flue products into the heater room.

6.Avoid oversize vent piping or extremely long runs of the pipe which may cause excessive cooling and condensation. Rule of Thumb: The total length of the vent, including the connector and any offset, should not exceed 15 feet for every inch of vent diameter. Longer total lengths shown in venting tables are based on maximum capacity, not condensation factors.

7.When the installation of a draft fan is necessary in connecting a venting system to a the heater, the installation should be engineered by competent personnel following good engineering practices. The draft fan supplier should be consulted for correct size. The installation should be in accordance with the latest edition of ANSI Z223.1 and/or, in Canada, CSA

B149.1 requirement and any local codes having jurisdiction. When a draft fan is installed, a suitable draft switch must be wired into the heater control circuit at terminal designated “Field Interlock” to prevent firing of the heater unless a positive draft has been established.

2.3 Installation of Outdoor Heaters

1.Locate the heater to provide the minimum clearances as listed in Table 1, “Placement of Heater”.

2.Do not place the heater in an enclosure or wall recess. Avoid locations where wind deflection off structures might cause down draft. When such wind conditions are possible, place the heater at least three (3) feet from the structures.

3.Never install the heater under any kind of roof overhang. Do not place the heater below or adjacent to any doors, windows, louvers, grills,

Window

Or Grill

Indoor

Room

Figure 7. Incorrect Outdoor Installation.

etc. which connect in any way with an inhabited area of a building. This includes other structures such as garages or utility rooms (see Figure 7).

4.Although these models are CSA designed certified for outdoor installations, such installations are not recommended in areas where the danger of freezing exists unless proper precautions are taken for freeze protection.

2.4Gas Supply and Piping

Review the following instructions before

proceeding with the installation.

1.Verify that the heater is fitted for the proper type of gas by checking the rating plate. Bradford White heaters are normally equipped to operate below a 2000 foot altitude. Heaters equipped to operate at higher altitudes have appropriate stickers or tags attached.

Note: These figures are for Natural Gas (.65 Sp. Gr.), and are based on 1/2" water column pressure drop. Check supply pres- sure with a manometer, and local code requirements for varia- tions. For LPG, reduce pipe diameter one size, but maintain a 1" minimum diameter. A normal number of Tees and elbows have been taken into allowance.

Table 3. Gas Piping Sizes.