AEG 8000038784_00_BAL_en user manual Menu Structure Status Display Functions Description

2.Display

2.1.3.Status

	Menu Structure - Status
2	Display Functions				Description
	[-] Ambient Conditions				Only applicable if sensors are connected
		Irradiance: 1400W/m2			Irradiance. “NC” if not connected
		PV module temp: 100 oC			PV module temperature. “NC” if not connected
		Ambient temp: 20 oC			Ambient temperature. “NC” if not connected
		Irr. sensor temp: 20 oC			Irradiation sensor temperature. “NC” if not connected
	[-] Photovoltaic
		[-] Present values
			[-] PV input 1
				Voltage: 1000V	Voltage detected at PV input 1
				Current: 15.0 A	Current detected at PV input 1
				Power 10000 W	Power detected at PV input 1
			[+] PV input 2
			[+] PV input 3		Not visible if inverter type is 10 kW
		[-] Isolation Resistance
			Resistance: 45 MΩ		PV isolation at start up
		[-] PV Input Energy
			Total: 369000kWh		Daily production of all PV inputs
			PV1: 123000 kWh		Daily production of PV input 1
			PV2: 123000 kWh		Daily production of PV input 2
			PV3: 123000 kWh		Daily production of PV input 3
		[-] PV Configuration
			PV input 1: Individual		Configuration of PV input 1. The configuration is only shown when the in-
					verter is in Connecting or On grid mode.
			PV input 2: Individual
			PV input 3: Individual
	[-] AC-grid
		[-] Present Values
			[-] Phase 1
				Voltage: 250 V	Voltage on phase 1
				Current: 11.5 A	Current on phase 1
				Frequency: 50 Hz	Frequency on phase 1
				Power: 4997 W	Power on phase 1
			[+] Phase 2
			[+] Phase 3
		[-] Residual Current Monitor
			Current: 350 mA		Residual current in mA
	[-] Grid management				Only visible if the inverter is set up for feed-in to medium or high voltage
					grid (e.g. _MV country is the selected country)
		[-] Power level adjustment
			[-] Present limit: 100 %		Maximum allowed power output in % of nominal power output. “Off”
					means that the power level functionality has been disabled in the inverter.
		[-] Reactive power			Only displayed if the current country setting is an MV country or custom,
					and in Protect PV versions.
			Setpoint type: Off		The setpoint type for Reactive Power. Off means that no internal setpoints
					are used, but the inverter will accept an external setpoint.
			Value: -		The current value of the setpoint for reactive power, the unit depends on
					the selected setpoint type.

Table 2.3: Status

6 8000038784_00_BAL_en / L00410565-01_02