American Water Heater 395T1996NOX, ULTRA LOW NOx SERIES 104 For Your Safety Read Before Operating

Page 19

LIGHTING AND OPERATING LABEL

FOR YOUR SAFETY READ BEFORE OPERATING

 

 

 

 

WARNING: If you do not follow these instructions exactly, a fire or

 

 

 

 

 

 

 

 

explosion may result causing property damage, personal injury

 

 

 

 

 

or loss of life.

 

 

 

 

 

FLAMMABLE

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BEFORE OPERATING: ENTIRE SYSTEM MUST BE FILLED WITH WATER AND AIR PURGED FROM ALL LINES.

 

 

A. This appliance does not have a pilot. It is equipped with

If you cannot reach your gas supplier, call the fire

 

department.

 

 

an ignition device which automatically lights the burner.

 

 

C. Use only your hand to push the control buttons. Never use

 

 

Do not try to light the burner by hand.

 

B. BEFORE OPERATING smell all aroung the area for gas.

tools. If the control buttons will not push in, don’t try to

 

repair them, call a qualified service technician. Force or

 

 

Be sure to smell next to the floor because some gas is

 

 

attempted repair may result in a fire or explosion.

 

 

heavier than air and will settle on the floor.

 

 

D. Do not use this appliance if any part has been under water.

 

WHAT TO DO IF YOU SMELL GAS

 

 

Do not try to light any appliance.

Immediately contact a qualified installer or service agency

 

 

 

 

 

to replace a flooded water heater. Do not attempt to repair

Do not touch any electric switch;

the unit. It must be replaced!

do not use any phone in your building.

 

Immediately call your gas supplier from a neighbor's

 

phone. Follow the gas suppliers instructions.

 

OPERATING INSTRUCTIONS

1.STOP! Read the safety information above on this label.

2.Set the ON/OFF switch on the control box to the “OFF” position.

3.Set the thermostat to the lowest setting.

4.This appliance is equipped with a device which automatically lights the burner.

DO NOT TRY TO LIGHT THE BUNER BY HAND.

5. Wait five (5) minutes

 

to clear out any gas.

 

If you then smell gas,

 

STOP! Follow “B”

 

in the safety information above on this label. If you don’t smell gas, go to the next step.

6.Turn on all electrical power to the appliance.

7.Set the ON/OFF switch on the control box to the “ON” position.

8. Set the thermostat to the desired setting.

CAUTION: Hotter water increases the risk of scald injury. Consult the instruction manual before changing temperature.

9.If the appliance will not operate, follow the instructions “TO TURN OFF GAS TO APPLIANCE” and call your technician or gas supplier.

WARNING: TURN OFF ALL ELECTRIC POWER BEFORE SERVICING.

ON OFF

TO TURN OFF GAS TO APPLIANCE

1.Set the thermostat to the lowest setting.

2.Set the ON/OFF switch on the control box to the “OFF” position.

3.Turn off all electrical power to the appliance if service is to be performed.

Servicing should only be performed by a Qualified Service Technician

17

Image 19
Contents For Models BCL Commercial GAS Water HeatersPage Table of Contents Qualifications Service WarningService Reminder IntroductionTools Required GAS Pressure Requirements Installation ConsiderationsGas and Electrical Characteristics Multiple Appliance InstallationsAIR Supply Contaminated AIR MAKE-UP AIR Direct Communication with OutdoorsThermal Expansion Power SupplyAIR Requirements Closed Water SystemsFeatures and Components Burner Replacement Blower and Burner AssemblyPage Flame Sensor Spark Igniter, Flame Sensor, Sight GlassSpark Igniter / Flame Sensor / Control Timing Spark IgniterBCL Venting Installation Venting Category and MaterialsVenting Minimum ClearancesExterior Clearances Type B GAS Vent Venting Tables Technical Venting DataSequence of Operation Operation and ServiceYES Sequence of Operation Flow ChartLighting and Operating Label For Your Safety Read Before OperatingComplaint Cause Remedy User Qualified Agency TroubleshootingPressure Switches All Models Controls Overview Control BOX AssemblyHigh Limit SWITCH/ Digital Thermostat Status Display Lights Digital Thermostat LED Indication ActionConditions Continuity Check of High Limit ECOThen Ohms Resistance Table Upper Temperature Probe Continuity CheckOhms Lower Temperature Probe Continuity Check Ignition Control Wiring Terminals DescriptionFailure to Light Lockout Start UP/ Flame RECOVERY/ Safety LockoutStart UP Heat Mode Flame FAILURE- Recycle ModeFlame Sensor Current Check Fault ConditionsTroubleshooting Guide for Ignition Control Internal Control FailureSW2 SW4 Used for UGB Blower Speed ControlPIN Connections PIN Number Description Wiring Diagram American Water Heaters

381T1546NOX, 395T1996NOX, BCL, 381T1206NOX, 395T2506NOX specifications

The American Water Heater Ultra Low NOx Series represents a significant advancement in water heating technology, aiming to meet stringent environmental regulations while delivering reliable hot water for residential applications. Models such as the 104,395T1806NOX, 395T2506NOX, 381T1206NOX, and BCL are designed to prioritize efficiency, performance, and compliance with the latest emission standards.

One of the defining features of the Ultra Low NOx Series is its innovative combustion technology. These water heaters utilize a state-of-the-art gas burner that dramatically reduces nitrogen oxide (NOx) emissions, ensuring compliance with local and federal regulations. This technology not only benefits the environment but also contributes to improved indoor air quality.

Efficiency is a hallmark of the Ultra Low NOx Series, with models designed to maximize energy savings while delivering consistent hot water. They feature a user-friendly, adjustable thermostat, providing homeowners with the ability to set their desired water temperature for optimal comfort. In addition, the insulation on these water heaters is designed to minimize heat loss, ensuring that energy consumption is kept to a minimum.

The Ultra Low NOx models are equipped with an easy-to-use digital control panel that allows homeowners to monitor and adjust settings with ease. This convenience is enhanced by advanced diagnostics, which provide real-time alerts regarding system performance and maintenance needs. This proactive approach helps extend the lifespan of the unit and enhances reliability.

Safety is another crucial characteristic of the Ultra Low NOx Series. Each model is equipped with safety features such as a flame rollout switch and a fully automatic gas shut-off, which ensure that the system operates safely under various conditions.

In terms of installation and maintenance, these models are designed with user-friendly features, making the process simpler for technicians. The compact design allows for flexible installation options, even in tighter spaces.

Overall, the American Water Heater Ultra Low NOx Series, including the 104,395T1806NOX, 395T2506NOX, 381T1206NOX, and BCL models, represents an excellent choice for homeowners seeking an efficient, reliable, and environmentally responsible water heating solution. With a focus on reducing emissions and enhancing performance, these models are built to meet the demands of today's conscientious consumers.