American Water Heater Commercial Ultra Low NOx Gas water Heater, BBCN375T754NV Table of Contents

Page 3

TABLE OF CONTENTS

Page

Page

ROUGH-IN DIMENSIONS

2

FOREWORD

2

GENERAL SAFETY INFORMATION

2-4

Precautions

3

Grounding Instructions

3

Chemical Vapor Corrosion

3

Extended Non-use Periods

3

Insulation Blankets

4

High Altitude Installations

4

Circulating Pump

4

INSTALLATION INSTRUCTIONS

4-9

Required Ability

4

Locating The Heater

4

Clearances

5

Hard Water

5

Air Requirements

5

Venting

6

Thermometers (Not Supplied)

7

Combination Water (Potable) Heating and Space Heating

7

Relief Valve

7

Gas Piping

7

Heater Wiring

8

Wiring Diagram

8

Purging

9

Gas Pressure Regulation

9

OPERATION

9

To Operate The Heater

9

Lighting Instructions

10

Temperature Regulation

11

Checking Venting

11

High Temperature Limit Switch

11

SERVICE INFORMATION

12-13

Main Burner and Igniter

12

Checking Gas Input

12

Vent System

12

Blower Maintenance

13

Relief Valve

13

Hot Water Odor

13

Winter Protection

13

Replacement Parts

13

PREVENTIVE MAINTENANCE

13-14

Procedure for Periodic Removal Of Lime Deposits

13

Deliming Solvents

13

Tank Cleanout Procedure

14

CHECKLIST

15-16

Condensation

15

Anode

15

Service & Repair

16

TROUBLESHOOTING

17-20

NOTES

21-22

LIMITED WARRANTY

23

GENERAL SAFETY

INFORMATION

PRECAUTIONS

DO NOT USE THIS water heater IF ANY PART HAS BEEN UNDER WATER. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

IF THE UNIT IS EXPOSED TO THE FOLLOWING, DO NOT OPERATE HEATER UNTIL ALL CORRECTIVE STEPS HAVE BEEN MADE BY A QUALIFIED SERVICEMAN.

1.EXTERNAL FIRE.

2.DAMAGE.

3.FIRING WITHOUT WATER.

4.SOOTING.

Heater must be protected from freezing downdrafts during shutdown periods.

GROUNDING INSTRUCTIONS

This water heater must be grounded in accordance with the National Electrical Code and/or local codes. These must be followed in all cases.

This water heater must be connected to a grounded metal, permanent wiring system; or an equipment grounding conductor must be run with the circuit conductors and connected to the equipment grounding terminal or lead on the water heater, see Figure 5.

CHEMICAL VAPOR CORROSION

WARNING

CORROSION OF THE FLUEWAYS AND VENT SYSTEM MAY OCCUR IF AIRFORCOMBUSTIONCONTAINSCERTAINCHEMICALVAPORS. SUCH CORROSION MAY RESULT IN FAILURE AND RISK OF ASPHYXIATION.

Spray can propellants, cleaning solvents, refrigerator and air conditioning refrigerants, swimming pool chemicals, calcium and sodium chloride (water softener salt), waxes, and process chemicals are typical compounds which are potentially corrosive. Do not store products of this sort near the heater. Also, air which is brought in contact with the heater should not contain any of these chemicals. If necessary, uncontaminated air should be obtained from remote or outside sources. The limited warranty is voided when failure of water heater is due to a corrosive atmosphere. (Refer to the limited warranty for complete terms and conditions.)

EXTENDED NON-USE PERIODS

WARNING

HYDROGEN GAS CAN BE PRODUCED IN A HOT WATER SYSTEM SERVED BY THIS HEATER THAT HAS NOT BEEN USED FOR A LONG PERIOD OF TIME (GENERALLY TWO WEEKS OR MORE). HYDROGEN GAS IS EXTREMELY FLAMMABLE. To reduce the risk of injury under these conditions, it is recommended that the hot water faucet be opened for several minutes at the kitchen sink before using any electrical appliance connected to the hot water system. If hydrogen is present, there will probably be an unusual sound such as air escaping through the pipe as the water begins to flow. THERE SHOULD BE NO SMOKING OR OPEN FLAME NEAR THE FAUCET AT THE TIME IT IS OPEN.

3

Image 3
Contents Notify Owner to Keep for Future Reference Place These Instructions Adjacent to HeaterTOP View DimensionsRecovery Ratings Input Rate GAS and Electrical CharacteristicsTable of Contents Installation Instructions Unconfined Space ClearancesHard Water AIR RequirementsVent Connection VentingSystem Connections Combination Water Potable Heating Space HeatingRelief Valve GAS PipingWiring Diagram and Schematic Heater WiringGAS Meter Size Natural Gases only PurgingGAS Pressure Regulator To Operate the HeaterWhat to do if YOU Smell GAS For Your Safety Read Before OperatingChecking Venting Temperature RegulationChecking GAS Input Service InformationHigh Temperature Limit Switch ECO Main Burner and IgniterPreventive Maintenance FLO-JUG Method of Deliming Tank Cleanout ProcedureChecklist CondensationAnode Water Heating Cycle TroubleshootingService and Repair GAS and Electric Power are ON,OFF/ON Switch is onLeaking T&P Valve Not Enough or no HOT WaterCondensation Water LeaksTrouble Shooting Troubleshooting GuidelinesD E F Black resistor wire between pins 3 & 4 with an ohm meterUnplug the ignitor assembly plug from the control. Check Page Page Conditions and Exceptions Service and Repair ExpensesClaim Procedure ALL Other Parts

BBCN375T754NV, Commercial Ultra Low NOx Gas water Heater specifications

The American Water Heater BBCN375T754NV is a standout in the realm of commercial water heating solutions, specifically designed to meet the demands of businesses requiring high efficiency and reliability. This ultra-low NOx gas water heater is engineered to reduce nitrogen oxide emissions, adhering to strict environmental regulations, which makes it an ideal choice for those conscious of their ecological footprint.

One of the main features of the BBCN375T754NV is its impressive capacity of 75 gallons, making it suitable for various commercial applications, including restaurants, hotels, and manufacturing facilities. This model is built to provide a consistent and rapid supply of hot water, ensuring that users have access to the hot water they need without interruption.

The heater is equipped with a powerful gas burner system, providing an input of 375,000 BTUs per hour, which guarantees robust performance even during peak demand times. This high input rate allows for quick recovery and reduces waiting times for hot water delivery, an essential factor in maintaining operational efficiency.

In terms of technology, the BBCN375T754NV incorporates advanced combustion management systems that optimize gas consumption and efficiency. This ensures that the heater operates at maximum capacity while minimizing energy waste. Additionally, the unit features a robust insulation system designed to reduce heat loss, further contributing to its energy-efficient performance.

Another important characteristic of this water heater is its durable construction. Made from high-quality materials, including a glass-lined tank for corrosion resistance, the BBCN375T754NV is built to withstand the rigors of a commercial environment. The unit comes with a built-in anode rod to enhance longevity and minimize maintenance needs.

Furthermore, the heater includes an easy-to-navigate digital display that simplifies temperature adjustments and monitoring. This feature enables operators to easily manage the system settings, ensuring optimal performance and safety.

To sum up, the American Water Heater BBCN375T754NV is designed for those who need an efficient, reliable, and environmentally friendly solution to their commercial hot water requirements. With its high capacity, advanced technologies, and durable design, it stands as a robust option for businesses looking to enhance their water heating systems while adhering to environmental standards.