A.O. Smith 186589-004, GDVT-50, GDV-50, GDV-75, GDV-40 instruction manual Temperature Regulation

Page 19

TEMPERATURE REGULATION

TEMPERATURE REGULATION

HOT WATER CAN SCALD: Water heaters are intended to produce hot water. Water heated to a temperature that will satisfy space heating, clothes washing, dish washing, and other sanitizing needs can scald and permanently injure you upon contact. Some people are more likely to be permanently injured by hot water than others. These include the elderly, children, the infirm, or physically/mentally handicapped. If anyone using hot water in your home fits into one of these groups or if there is a provincial, state law or local code requiring a specific hot water temperature at the tap, then you must take special precautions. Never allow small children to use a hot water tap, or to draw their own bath water. Never leave a child or handicapped person unattended in a bathtub or shower.

It is recommended that lower water temperatures be used to avoid the risk of scalding. It is further recommended, in all cases, that the water temperature be set for the lowest temperature that satisfies your hot water needs. This will also provide the most energy efficient operation of the water heater.

Figure 28 shows the approximate water temperatures produced at various thermostat dial settings. Short repeated heating cycles caused by small hot water uses can cause temperatures at the point of use to exceed the thermostat setting by up to 17°C (30°F). If you experience this type of use you should consider using lower temperature settings to reduce scald hazards.

Valves for reducing point-of-use temperature by mixing cold and hot water are available (see Figures 2 & 7). Also available are inexpensive devices that attach to faucets to limit hot water temperatures. Contact a licensed plumber or the local plumbing authority.

SHOULD OVERHEATING OCCUR OR THE GAS SUPPLY FAIL TO SHUT OFF, TURN OFF THE MAIN MANUAL GAS CON- TROL VALVE TO THE APPLIANCE (SEE FIGURE 1).

NOTE: A water temperature range of 49°C-60°C (120°F-140°F) is recommended by most dishwasher manufacturers. The ther- mostat of this water heater has been factory set at its lowest position (PILOT LIGHTING). It is adjustable and must be reset to the desired temperature setting to reduce the risk of scald injury. The mark () indicative of approximately 49°C (120°F) is preferred starting point. Some provinces may have a require- ment for a lower setting.

Turn the water temperature dial clockwise () to decrease the temperature, or counterclockwise () to increase the tempera- ture.

Temperature Setting

Time to Produce 2nd & 3rd

Degree Burns on Adult Skin

 

 

 

VERY HOT= approx. 71°C

About 1/2 second

(160°F)

 

C = approx. 66°C (150°F)

About 1-1/2 seconds

B = approx. 60°C (140°F)

Less than 5 seconds

A = approx. 55°C (130°F)

About 30 seconds

= approx. 49°C (120°F)

More than 5 minutes

LOW = approx. 27°C (80°F)

-----------------------------

FIGURE 28

19

Image 19
Contents Residential GAS Water Heaters Important Definitions Safe INSTALLATION, USE and ServiceGeneral Safety Introduction Table of ContentsGET to Know Your Water Heater Replacement Parts Typical InstallationHotter Water can Scald Mixing Valve UsageFacts to Consider about the Location Locating the NEW Water HeaterVentilation for Appliances Located in Confined Spaces Insulation BlanketsVent Termination General Installing the NEW Water HeaterRequired Ability Inspect ShipmentValve and Pipe Insulation if Supplied TEMPERATURE-PRESSURE Relief ValveClosed Water System Water Potable Heating and Space HeatingGAS Piping GAS Piping with Flexible Connector Sediment Traps Filling the Water Heater High Altitude InstallationsVenting Vent Terminal Clearances Combustion AIR and VentilationHigh Rise Vent Arrangement DV Termination Safety CoverVent Connections Locating Clearance Hole for VentUncompressing the Corrugated Tubing Vent AssemblySecuring Vent Termination Assembly to the Exterior Wall Standard Vent ArrangementOffset Vent Arrangement Figure a Temperature Regulation Temperature RegulationOperational Conditions For Your InformationExternal Damage Start UP ConditionsAIR in HOT Water Faucets Venting System Inspection MaintenancePilot and Main Burner Cathodic Protection Anode Temperature & Pressure Relief ValveAnode ROD Maintenance DrainingDrain Valve Washer Replacement Leakage Checkpoints ServiceProblem Possible Causes Correction Troubleshooting GuidelinesThermostat Fails to Slow HOT Water RecovERY Drip from Relief ValvePage Conditions and Exceptions Series Tank PartsXCV, XCVL, XCVH, XVR XCVT, XcvxLimitation on Implied Warranties Service and Labor ResponsibilityClaim Procedure Installation InformationTennessee Waltz Parkway Ashland CITY, TN

186589-004, GDVT-50, GDV-75, GDV-40, GDV-50 specifications

A.O. Smith is a recognized name in the water heating industry, known for its reliable and efficient water heaters. Among its notable products are the GDV-50, GDV-40, GDV-75, GDVT-50, and 186589-004 models. These water heaters offer enhanced performance, energy efficiency, and modern technologies suited for residential and commercial applications.

The GDV series includes the GDV-50, GDV-40, and GDV-75 models, which feature a robust design typically made from high-quality materials to ensure longevity. These units come equipped with advanced insulation, which minimizes heat loss and increases efficiency, making them excellent choices for households with varying hot water needs.

The GDV-50 model boasts a tank capacity of 50 gallons, making it suitable for medium to large households. It features a powerful heating element that heats water quickly, providing ample hot water for daily use. Meanwhile, the GDV-40 is designed for smaller households with a 40-gallon capacity. This model strikes a balance between size and efficiency, catering to lighter hot water demands while maintaining excellent performance.

For larger households, the GDV-75 provides a 75-gallon capacity, ensuring that even the most demanding hot water applications can be met with ease. This model is particularly ideal for families that require hot water in large quantities or at peak times.

The GDVT-50 is a versatile model that features advanced technology, such as an integrated digital display that allows users to monitor and adjust settings easily. This offers greater control over temperature settings and energy usage, making it not only convenient but also more energy-efficient.

The A.O. Smith 186589-004 is an accessory designed for specific model enhancements that improve overall performance and safety. It may include additional safety features, such as high-temperature limit switches and automatic shut-off mechanisms that provide peace of mind for users.

All these models are equipped with A.O. Smith’s innovative technologies, including advanced thermostat controls and durable components designed to withstand frequent use. They typically come with generous warranties, underscoring the manufacturer's commitment to quality and customer satisfaction.

In summary, A.O. Smith water heaters, particularly the GDV-50, GDV-40, GDV-75, GDVT-50, and 186589-004, are built for efficiency, reliability, and performance. With various capacities and the latest technologies, they cater to the diverse needs of homeowners and businesses, ensuring that hot water is always available when needed.