Genie 2022, 2042, 2024 UP/DOWN Force, Erase OPEN/CLOSE Travel Limit, Contact Reverse Test, Testing

UP/DOWN FORCE

1.By turning the "Close Force Control" CLOSE clock- wise, the DOWN force can be increased. By turning the "Close Force Control" CLOSE counter- clockwise, the DOWN force can be decreased. Set the DOWN force level at the minimum force required to close door without reversing.

2.Once the desired level is selected, this stores the necessary force level for the DOWN direction in memory.

3.By turning the "Open Force Control" OPEN clockwise, the UP force can be increased. By turning the "Open Force Control" OPEN counter-clockwise, the UP force can be decreased. Set the UP force level at the minimum force required to open door without stopping.

4.Once the desired level is selected, this stores the necessary force level for the UP direction in memory.

ERASE - OPEN/CLOSE TRAVEL LIMIT

1.Press and hold both of the "SET" buttons ( SET & SET ) together until the green indicator light blinks (about 5 seconds).

2.All close and open travel limit settings are erased. Then follow the steps above to reprogram close and open travel limits.

NOTE: The opener will not close the door automatically unless the Safe-T-Beam®System is installed.

	Up Force
OPEN	Control
	Adjustment
	(Increasing Force)
FORCE	CLOCKWISE
	ROTATE
	(Decreasing Force)
	ROTATE
CLOSE	COUNTER-CLOCKWISE
	Down Force
	Control
	Adjustment

FIG. 6-5 Force Control Adjustment.

CONTACT REVERSE TEST

The force adjustments and limit switch settings MUST BE COMPLETED before testing.

1.Testing.

•Open garage door using Wall Control.

–Place a 2" x 4" board (laid flat) under center of garage door opening (FIG. 6-6).

•Close door using Wall Control.

•When door contacts board, the door must stop (within 2 seconds) and reverse direction returning to open position.

2.Adjustment.

•If the door does not properly reverse.

–Check to see if door has "close" limit programmed. It should not have reached its "close" limit before hitting board.

–If the door STOPS but does not reverse, decrease "CLOSE FORCE" control CLOSE setting slightly (turn it counter-clockwise).

•Test again. Repeat as necessary until door reverses upon contacting board.

FIG. 6-6 2 x 4 under center of door opening.

22 PN 37026501206 01/27/2012