Chamberlain MT60P manual Install the Pole Adaptor, Install the Stop Collar and Pole

8 INSTALL THE TROLLEY AND IDLER PULLEYfig 1

Slide the trolley assembly (1) onto the pole (3) taking note
of the door direction arrow (fig 1). The trolley should be
located midway along the pole.	2
Insert the pole (3) into the idler pulley assembly (2) as
illustrated.
	1

3

9INSTALL THE POLE ADAPTOR

1

Remove the four (factory fitted) washered screws (1).

THESE WASHERED SCREWS MUST BE USED TO FASTEN THE POLE KIT ADAPTOR.

Place the pole adaptor bracket on the opener as illustrated using the 4 washered screws (1) to fasten in place (tightento between 20-22Nm).

1

5

10 INSTALL THE STOP COLLAR AND POLE

Absolute minimum

Slide the stop collar (1) onto the pole (2) (opener

stop collar

end). Fit the pole through the adaptor bracket (3) to

setting

the opener, then fasten the stop collar above the edge of the lens cover as illustrated.

Move the stop collar to the open limit on the pole, set the stop collar back 25mm toward the opener and fasten in place. Observe the absolute stop position.

2

3 1