WASH AND DRY
Step on Nozzle Setting pedal if necessary to switch from HARD FLOOR DRY VAC to
WET SCRUB & VAC
position.
Slide Brush On/Off
switch to the ON
position.
Pull Solution Trigger to start the flow of
cleaning solution. NOTE; Cleaner will
continuously dispense solution until Solution
Trigger is released.
With solution On/Off trigger held down, slowly push unit forward. Release solution On/Off trigger and pull unit backward in the same area cleaned to remove dirty water and solution from hard floor.
Overlap strokes by one inch to prevent streaking. (For heavily soiled areas, repeat if necessary).
IMPORTANT: If the unit stops picking
up dirty ater and/or the motor changes
to a hi,dirty water tank is full be emptied. See page 13.
RNING
To r, uce the risk of Injury from
_1: unplug before
IMPOI 4T: When changing between
hard nd carpet cleaning modes, use the correct nozzle:
;leaning - tangerine nozzle
ning - green nozzle
bee)
Turn Nozzle Lock Tab counterclockwise to unlock nozzle from cleaner.
NOZZLE
LOCK TAB
Pull nozzle forward to
remove completely from Nozzle Lock.
Store nozzle in Nozzle Storage Holster and clip,
10