BRUSHROLL RESET BUTTON
IMPORTANT: Your cleaner contains a reset button to protect the permanent belt should the brushroll clog. If this occurs, unplug the unit, remove debris from brushroll, and push reset button prior to resuming operation.
THERMAL PROTECTOR
IMPORTANT: Your cleaner contains a thermal protective device to shut off the motor to avoid overheating. If this happens, turn the unit off and unplug the cleaner. Inspect the nozzle inlet for blockage. Empty the Dirty Water Tank and clean filter. After approximately 30 minutes, the motor will have cooled and the vacuum will be ready to use. NOTE: The cleaner must remain unplugged during the 30 minute cooling period.
AFTER CLEANING:
Allow carpet to dry completely. Try not to walk on the carpet until it is dry.
If you need to walk on the carpet, place white towels on the areas you want to walk.
If the carpet is not dry and furniture must be placed back in the room, use plastic or foil under the furniture to prevent staining the carpet.
Thoroughly clean the dirty water tank with warm tap water.
WARNING
To reduce the risk of Injury from moving parts unplug before servicing•
debris.
TAB
EMPTY TANK-IN-TANK TM
Remove
and tilting out from cleaner.
Grasp tab on filter/float assembly and pull up to remove from tank. Empty con- tents of Dirty Water Tank.
SYSTEM
disconnect from
Clean and Dirty Water Tanks before storing. See Storing Cleaner
on Page 15 for
electrical outlet._ Rinse and dry the additional storage
Turn cleaner off and
instructions.
13