Chapter 6 Managing Virtual Ports
Avaya M770 ATM Switch User’s Guide 89
Resetting signalling statistics
To clear signalling counter for a virtual port, use the vport sig resetstats
command:
Managing Connections
Listing all virtual circuits
To list the details of all virtual circuits, use the vport connections all
command.
The vport connections all command displays all SVCs, PVCs, and internal
virtual circuits such as ILMI signalling that are set up on the M770 ATM Switch.
Information displayed in the output is described in Table 6.7.
Listing switched virtual circuits
To list the details of all SVCs, use the vport connections svcs command.
Command: M15-155s8:/>vport sig resetstats <vport id>
Example: M15-155s8:/>vport sig resetstats 2.9.0
Parameter: <vport id> The virtual port identifier is displayed as
<slot>.<port>.<virtualport number>
Output: Done!
Command: M15-155s8:/>vport connections all
Command: M15-155s8:/>vport connections svcs [nomesh] [addr] [td]
[<vport id>] [src|dst] [<vportid>] [dir]
Example: M15-155s8:/>vport connections svcs nomesh addr 8.1.0
Parameters: [nomesh] Lists SVCs passing through the vport (except for LANE
mesh SCVs)
[addr] Lists the ATM addresses where available
[td] Displays the ATM Traffic Descriptor
[<vport id>] Lists all SVCs passing through the vport
[<vport id>]
[src|dst] Lists the incoming/outgoing SVCs from/to the vport
[<vport id>]
[<vport id>] Lists all SVCs between the two vports
[<vport id>]
[<vport id>]
dir
Lists all SVCs from the 1st vport to the 2nd vport