Chapter 5 Managing Physical Ports
44 Avaya M770 ATM Switch User’s Guide
Displaying counter information for DS3 physical ports
You can view counter information specific only to DS3 modules by entering the
command: pport show ds3counters. The information this command displays
will not appear when you enter the command: pport show counters.
DS3 Counter information is accumulated in 15 minute completed intervals for the
last 24 hours the system was up. Fewer than 96 intervals of information will be
available if the module has been restarted within the last 24 hours.
There are 96 (15 minute) intervals numbered 1-96 with interval 0 always the current
interval, interval 1 the interval most recently completed, and interval 96 the earliest
possible interval. As soon as the current 15 minute interval ends, a new current
interval 0 starts.
The pport show ds3counters current command displays counter
information only for the current interval. The pport show ds3counters
interval command displays a historical record of the counters for the completed
intervals (up to 96 completed intervals) during the last 24 hours the system was up.
Note: The pport show ds3counters command displays counter information
specific only to DS3 modules.
Rx Errors The number of cell errors that have been received through the
physical port.
Command: M4-DS3s8:/>pport show ds3counters [ne|fe] [current|total|interval [<pport id>]]
Example: M4-DS3s8:/>pport show ds3counters ne current
Parameters: ne To specify that the counter information is supplied from the near
end.
fe To specify that t he counter information is supplied from the far end.
current To specify that the ne/fe counter information is supplied from the
current interval for all ports.
total To specify that the ne/fe counter information is supplied for the last
24 hours for all ports.
interval [pport id] To specify that the ne/fe counter information is supplied in all
intervals (up to 96) for all ports.
If the physical port identifier is entered, only the interval counters
for the specified DS3 port are displayed. If no value is specified, then
the interval counters for all DS3 ports are displayed.
Table 5.2 Output from the pport show counters command
Field Description