Chapter 2 GettingStarted
18 Avaya M770 ATM Switch User’s Guide
Following is a simple configuration example, which will enable you to start working
with the LANE services and to connect a network management station which uses
SNMP and CajunView Management.
1 You need to decide where you want the LECS. The following command creates
a local resilient LECS with priority 0 which advertises the well known address,
on the module (while the LECS priority is 0 it will not be elected as active):
To see all of the resilient LECS on the network type the following:
If the location of the LECS is resident on a different switch or module at the
wka, change the location of the LECS to be remote at the wka using the
following command:
2 If your management station is on an ELAN different than default, you might
need to create a new ELAN. In order to create a new ELAN, two things must be
performed. First, an entry for the ELAN must be defined in the LECS table, and
a LES/BUS pair must be defined for the ELAN.
To create an ELAN named elan1, you need to first define an entry for elan1 in
the LECS table, typing the following command, at the module which holds the
LECS:
3 After all of the ELANs have been defined, in the ELAN database, you need to
change the priority of the LECS to a priority higher than 0, so that it can
participate in the LECS election. If you will be using more than one resilient
LECS, configure one of the LECS to have a higher priority to the others using
the following command (this example changes the LECS priority to 200):
Then you need to define a distributed LES/BUS for elan1. To create a LES/BUS,
that will use the selectors a1 and b1 for their ATM addresses, type the following
command:
To Check if the LES registered its address with the LECS type:
To check if any Clients registered with the LES elan1 type:
M15-155s8:/>lane lecs priority 0
M15-155s8:/>lane lecs resilient show
M15-155s8:/>lane lecs location remote wka
M15-155s8:/>lane elan create elan1 auto ethernet
M15-155s8:/>lane lecs priority 200
M15-155s8:/>lane les create elan1 distributed ethernet a1 b1
M15-155s8:/>lane elan show
M15-155s8:/>lane les show