Chapter 17 Managing System Commands
Avaya M770 ATM Switch User’s Guide 233
Using Terminal Commands
These commands allow you to configure how the Avaya M770 ATM Switch
displays output on the terminal.
Viewing the pager status
The pager is a facility that enables you to view the information that the M770 ATM
Switch outputs to the screen, a number of lines at a time. By default, the pager is
enabled.
To display the pager status, use the terminal pager command.
Enabling the pager
If the pager is enabled, the M770 ATM Switch displays output on the terminal
screen, a number of lines at a time. To enable the pager, use the terminal pager
enable command.
Disabling the pager
If the pager is disabled, the M770 ATM Switch displays output on the terminal
screen continuously. To disable the pager, use the terminal pager disable
command.
Viewing the number of lines
If the pager is enabled, this is the number of lines that the M770 ATM Switch will
output before pausing. For more information about the pager, see Viewing the
prompt later in this chapter.
By default, the number of terminal lines is set to 24.
To display the current number of lines, use the terminal lines command.
Command: M15-155s8:/>terminal pager
Output: pager is enabled
Command: M15-155s8:/>terminal pager enable
Output: pager enabled
Command: M15-155s8:/>terminal pager disable
Output: pager disabled
Command: M15-155s8:/>terminal lines
Output: terminal ines: 24 (auto-detected) or
(user-configured)