Chapter 9 Managing Static Routing
Avaya M770 ATM Switch User’s Guide 119
Note: All ATM addresses that are entered in the routing table must begin with the
AFI that is supported by the switch. The current AFIs supported by a M770 ATM
Switch are 39, 47, and 45. For more information about these AFIs, see Viewing or
changing the switch prefix in Chapter 4, “Managing Miscellaneous Commands”.
Once routes have been added, you can view them using the route show
command. For more information about displaying the routes in a routing table, see
“Listing the routing entries in a routing table” on page 120.
Deleting a routing entry from the routing table
When you delete a routing entry that is currently being used for an established
connection, this connection will not be affected. The deletion will take effect next
time you set up the connection.
To delete a route from the routing table, use the route delete command.
Note: It is not recommended that you delete routes that were added dynamically by
ILMI.
Note: Internal routes that have been added to the routing table by an entity that is
internal to the switch (for example, by LANE services) cannot be deleted.
Command: M15-155s8:/>route delete <address> <vport id> [<vport id>...]
Examples: M15-155s8:/>route delete
39.00.00.00.00.00.00.00.01.f6.e0.00.21.11.31.6f.00.28.01 8.1.0
Parameters: <address> This can be either the 19-byte hexadecimal address or a
partial.
<vport id> A virtual port that was used to route to the specified ATM
address.