Avaya M770 - page 165

Chapter 10 Managing PNNI Routing
Avaya M770 ATM Switch User’s Guide 145
To show the admin status of all levels, use the following command:
Setting PNNI node admin status
Use the following command to set pnni node admin status. It takes effect only for
logical levels (greater than 1).
PNNI ATM addresses
The following command displays the ATM address of the PNNI node. The PNNI
node's ATM address is advertised in Nodal Information PTSE and is important
when the node is a PGL/LGN. In this case, an SVC-RCC shall be opened between
LGNs, i.e., between the PNNI node's ATM addresses.
Setting PNNI defaults for all parameters
Use the following command to set PNNI configuration with default parameters.
This request will set defaults for all configurable variables: PNNI node level, node
id, peer group id, restrict transit flag, pgle parameters, svce parameters and all the
timers for the pysical level. Changes won't take effect until the next reboot, except
for timers, restrict transit flag and PGLE parameters.
For logical levels, changes will take place immediately.
Note: Make sure t he admin st atus of tha t level is do wn when you use this co mmand
on the logical level.
Command: M15-155s8:/>route pnni config admin show
Output: Admin Status:
Level 1 - Up
Level 2 - Up
Level 3 - Down
Level 4 - Down
Level 5 - Down
Command: M15-155s8:/>route pnni config admin set <level> <up | down>
Command: M15-155s8:/>route pnni config atm_addr show [<level>]
Output: Atm address:
Level 1 - 39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.81
Level 2 - 39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.82
Level 3 - 39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.84
Level 4 - 39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.85
Level 5 - 39.03.00.00.00.00.00.00.00.00.00.00.00.00.40.0D.87.01.B8.86
Command: M15-155s8:/>route pnni config default <level>