Appendix B Using BOOT Loader
276 Avaya M770 ATM Switch User’s Guide
Activating a configuration file
You can restore an old configuration file stored in the flash directory that was
generated with the system snapshot command.
To activate a configuration file, use the flash config command.
Note: The restored configuration file will only be activated when the switch is next
rebooted.
Deactivating an active configuration file
To deactivate an active configuration file, use the flash config
disable command.
Deleting a file from the flash memory bank
To delete a file from the flash memory bank, use the flash delete command.
You will be asked to confirm the deletion.
Note: Once a file is deleted it cannot be recovered. The file must be downloaded
again.
You must not delete the config.data file without consulting Avaya Technical Support.
Command: M15-155s8:/>flash config <filename>
Example M15-155s8:/>flash config new_cfile
Parameters: <filename> The name of the configuration file that you wish to
activate
Command: M15-155s8:/>flash config disable
Output: Active configuration file has been disabled.
Command: M15-155s8:/>flash delete <filename>
Example M15-155s8:/>flash delete m770ATM
Parameter: <filename> The name of the file you wish to delete from the
flash directory.