Avaya M770 - page 35

Chapter 2 GettingStarted

Avaya M770 ATM Switch User’s Guide 15

• For the switches that are capable of becoming PGLs (as determine in step 4) do

the following:

1 Configure the level scope as determine in step 6 for all levels (1-5) using the

command:

2 Configure the leadership priority of the node in the lower level to a value

greater than 0.

3 Configure the Administrative Status of the node in the next higher level to

• Repeat the last step for all levels you have in the hierarchy.

Connecting to an end-station or edge device not supporting ILMI

If you are attaching an end-station or edge device that does not support ILMI then

you must configure a route to that device. For example, if you are connecting an

Avaya M400 Gate Switch LSA+ module to port 8.4.0 on the M770 ATM Switch, you

should configure the static routing by performing the following steps:

[assume that the ATM address of the LSA+ is

39.01.00.00.00.00.00.00.00.00.00.00.00.00.40.od.64.02.de.00]

Note: The ATM address should not include the selector.

M15-155s8:/>/route pnni config level set <level (1-5)> <level scope (1-

104)>

M15-155s8:/>/route pnni config pgle set <level-x (1-4)> 1 <leadership

priority (1-205)>

M15-155s8:/>/route pnni config admin set <level-x+1(2-5)> up

M15-155s8:/>route add

39.01.00.00.00.00.00.00.00.00.00.00.00.00.40.od.64.02.de 8.4.0