Chapter 17 Managing System Commands
Avaya M770 ATM Switch User’s Guide 235
Setting the linewrap
To set the linewrap, use the terminal linewrap command.
Viewing the prompt
To display the current system prompt, use the terminal prompt command.
Changing the prompt
To change the system prompt, use the terminal prompt command.
Note: The only value that should be changed is the prefix (e.g. M770). The sX
(X=current slot number) should not be written as a system prompt.
Command: M15-155s8:/>terminal linewrap {none | pager | terminal}
Example: M15-155s8:/>terminal linewrap pager
Parameter: none The line wrapping is carried out by the terminal. The M770
ATM Switch will not try to calculate how many lines have
actually been used on the terminal. In fact, it will assume that
no wrapping has occurred when performing pager functions.
pager When the line output by the M770 ATM Switch reaches the
defined terminal length, the M770 ATM Switch will insert a
line break and assume that no line wrapping is carried out by
the terminal.
terminal The line wrapping is carried out by the terminal. The M770
ATM Switch will keep a record of the number of lines (using
the terminal width).
Command: M15-155s8:/>terminal prompt
Output: prompt is “M15-155s8”
Example: M15-155s8:/>terminal prompt Caj770
Output: Caj770s8:/>