Maintenance and care
Brush removal and replacement
1.Turn OFF (0) the machine and unplug from the outlet.
2.Remove the dirty and clean water tanks
from the base of the machine. | 4. |
3.While standing behind the unit, lay the unit on its’ side (cord side down).
4.Looking at the bottom of the unit, find the center of the brush carriage where the carriage latch is located. It is between the brush assembly and wheels.
5.Pull the brush carriage towards you with 5. one hand until it stops. Pinch the car-
riage latch with the other hand while pulling the carriage towards you. The carriage should swing out to access brush end cover.
6.Remove three screws from endcap. Pull 6A. endcap off to release brush roll.
7.With cover removed, the brush comes out easily by tilting the loose end out of the carriage.
8.To replace the brush roll back into the
unit, place the large open end of the | 7. | |
brush onto the carriage and tilt opposite | ||
| ||
end back into place. (same image as 7, |
| |
just change arrow direction) |
|
9.With the brush sitting relatively straight up and down by itself, place endcap back on top and replace three screws. The brush will need to be held and cen- tered to the cover while placing it back 9. on.
10.Spin the brush by hand to make sure it turns freely with some minor resistance from the motor. Push brush carriage back into place with a light pull against the lock.
3.
6B.
8.
10.
15
w w w . b i s s e l l . c o m | 8 0 0 . 2 3 7 . 7 6 9 1 |