Clarke L26 manual Distilled Water only, Maintenance Procedures To Be Done Every Week

Page 21

Maintenance

8.Check the batteries and if necessary add distlled water after charging. The correct level is within 1/4 inch (1/2 cm) of the bottom of the tube in each cell.

CAUTION: Tap water may contain contami- nants that will damage batteries. Batteries must be refilled with

DISTILLED WATER ONLY.

WARNING: Lead acid batteries generate gases which can cause an explosion. NO SMOKING. Always wear eye protection and protective clothing when working near batteries.

9. Use a clean cloth and wipe the surface of the machine.

10.Charge the batteries. See the instruction in the section of this book called “How To Charge The Batteries”.

Maintenance Procedures To Be Done Every Week:

WARNING: Maintenance and repairs must be done by authorized personnel only. Always empty the solution tank and the recovery tank before doing any maintenance. Keep all fasteners tight.

WARNING: Always wear eye protection and protective clothing when working near batteries. Do not put tools or other metal objects across the battery terminals or the tops of the batteries.

CAUTION: To prevent damage to the machine, and discharge across the tops of the batteries, do not fill the batteries above the bottom of the tube in each cell. Wipe any acid from the machine or the tops of the batteries. Do not add acid to battery after installation.

NOTE: Always turn off key switch before servicing the machine.

WARNING: Always wear eye protection and protective clothing when working near batteries. NO SMOKING!

1.To inspect batteries, tip up recovery tank until it locks in the full open position. See figure 30. To close the tank, pull up on the latch arm and then slowly lower the tank to the closed position.

CAUTION: Before raising the tank, be sure tank is empty.

NOTE: There is an intermediate position available for holding the recovery tank open for charging batteries. See figure 31.

Figure 30

Figure 31

CLARKE TECHNOLOGY Operator's Manual - Encore L26 Cylindrical

Page -21-

Image 21
Contents Read this Book ManualTable of Contents Severe bodily injury or death. Read and observe all Danger Avertissement AdvertenciaClarke Technology Operators Manual -Encore L26 Cylindrical Introduction & Machine Specifications Introduction & Machine SpecificationsFigure #1 Procedures For TransportingProcedures For Transpoting Symbols Used on Encore L26 Cylindrical Symbols Used on Encore L26 Cylindrical Key Switch See , Item a Machine Control PanelHour Meter Not Illustrated Option Parking Brake Optional, See Figure Machine Controls and FeaturesHow To Install The Batteries How To Prepare the Machine For OperationBattery Maintenance How To Charge The Batteries How To Change or Rotate Brushes How To Operate The Machine How To Operate The SqueegeeHow To Fill The Solution Tank Operating The Machine How To Clean a Floor How To Clean a Very Dirty Floor Maintenance These Maintenance Procedures Must Be Done Every DayDo These Procedures When You Begin Your Work Period Do These Procedures When You End Your Work MaintenanceDistilled Water only Maintenance Procedures To Be Done Every WeekMaintenance For The Squeegee Adjusting Squeegee Tilt How To Adjust The SqueegeeAdjusting Squeegee Blades How to Center or Offset the Brush HeadHow to Level the Cylindrical Brush Head Squeegee Blades Description Assembly Clarke Technology Encore L26 Cylindrical Accessories 3/02Description Brushes Size Description Used ForClarke Technology Operators Manual -Encore L26 Cylindrical Encore There is no solution flow HOW to Correct Problems in the Machine Cause ActionProblem Cause Action Page Alto Product Support Branches Battery Warranty Clarke Technology Limited U.S. WarrantyAlways use genuine ClarkeTechnology Parts for repair Highway Springdale, Arkansas