Select tool
Your model includes some combination of the following tools, but may not include them all.
H
G
I
G. SpinScrub™ hand tool has rotating brushes for extra scrubbing action on small carpet areas, carpeted stairs and upholstery. For some models, the brushes can be removed for converting to the scrub module.
H. Stair/upholstery nozzle has a
I. Scrub module with detachable scrub pad attaches to the base of the SpinScrub™ hand tool (in place of brush module). Can be used to scrub stub- born areas such as scuff marks, dried spills, and in hard to reach areas on hard surfaces.
How to attach tools
J
K
Unplug deep cleaner from electrical outlet.
1.Place handle in upright position and remove hose from rack.
All tools attach to the hose in the same manner:
2.Connect tool to hose by sliding it onto connector until the tab (J) locks it securely.
Using your thumb, push forward and up on the latch (K) to remove tool.
Before using tool
It may be necessary to remove air from the system (“prime the pump”) so the clean solution will flow to the tool. Follow these steps:
1.Attach tool to hose and turn the deep cleaner ON.
2.Put the tool on a hard surface or against your hand to block off the suc- tion.
3.Wait a few seconds (can take up to 15 seconds). Then squeeze the trigger and begin cleaning.
Follow the instructions on pages
After using tool
Drain suction hose by turning deep cleaner ON and holding nozzle up for several minutes. Do not press trigger.
Unplug deep cleaner from electrical outlet.
Disconnect hose and solution tube from deep cleaner.
Drain solution tube by placing round end in sink and raising nozzle above your head. Press the trigger.
The tool caddy can be removed and hung on a coat hanger for storage.
12