Hoover SteamVacTM V2TM manual How to empty, Hoover detergent

Page 8

2-11

2-12

2-13

 

 

 

E

F

Carry tank to a sink.

Turn tank cap counterclockwise and remove cap.

Fill tank (E) (1 gallon) with hot tap water.

Replace tank cap and tighten.

To fill detergent container (F), turn cap counterclockwise and remove cap.

2-14

Fill container (16 oz.) with HOOVER Carpet/Upholstery Detergent or HOOVER Bare Floor Cleaner.

Do not use Bare Floor Cleaner on carpet or upholstery. Do not use any type of wax with your ‘SteamVa c ’deep cleaner.

NOTE: Use only HOOVER detergents.

They are specially formulated for use with your ‘SteamVac’ deep cleaner.

CAUTION: Detergents contain Anionic and Nonionic Surfactants. Avoid contact with eyes and skin. In case of contact with eyes, flush with cold water for 15 minutes. In case of contact with skin, wash with water. If irritation persists, call a physician. For Medical Information (U.S.) call 1-800-752-7869.

2-15

Position bottom of tank onto cleaner and pivot tank to snap it into place.

To assure proper results, use only

HOOVER detergent.

Replace container cap and tighten.

Recovery tank

2-16 H

2-17

(lower tank)

 

 

The recovery tank holds the dirty solu- tion that is picked up from the surface being cleaned.

When the recovery tank is full, the auto- matic shut-off will engage, suction will

stop (see page 7), and the tank must beG emptied.

How to empty

Turn deep cleaner off and unplug from electrical outlet.

To prevent possible leaking, remove clean water tank (Fig. 2-10) by pressing down on tank handle and pulling for- ward; set tank aside (do not set tank on furniture).

Step on handle release pedal (Fig. 2-3) and lower handle until it rests on the floor.

8

Turn recovery tank latches (G) outward (one on each side of tank).

Raise handle (H) straight up and lift tank off cleaner.

Carry tank to sink or drain.

Lower handle toward back of tank to unlock lid. Lift lid off tank.

Empty tank and reposition lid.

For full suction, it is important that the recovery tank lid is properly secured before cleaning.

Raise tank handle to carrying position and place it onto deep cleaner. Lower handle to front of tank.

Turn latches (one on each side of tank) inward to lock tank in place.

Raise handle of deep cleaner to upright position and reposition upper clean water tank.

Image 8
Contents Deep Cleaner Important Safeguards Contents AssemblyAttach hose/tool caddy Attach upper handleAttach hose/cord hook Storing hose and tools SpinScrub hand toolHow to reattach tool cover How to use ON/OFF switchHandle release pedal To transportBrush setting selector Wash/rinse switchCarrying handle Automatic shut offHoover detergent How to emptyTurn deep cleaner off and unplug from electrical outlet After cleaning How to cleanBefore you begin cleaning To clean nozzle Read Before you begin cleaning instructions onDo not clean over floor electrical out- lets Turn brushes on or OFF as desiredHow to attach bare floor attachment To clean floorUnplug cleaner from electrical outlet Attach hoseHow to attach tools Before using toolAfter using tool Select toolCleaning carpeted stairs Maintenance Disconnect cleaner from electrical outletRemovable brushes To remove brushesIf you have a Full One Year Warranty Domestic Use