Storing hose and tools

1-9

Identify the hose parts before storing hose.

G. Nozzle connector end H. Solution tube

1-10

Press hose, a few inches from nozzle connector end, into caddy. Bring hose up and over top of caddy.

1 - 11

Press hose into opposite side of caddy. Loop hose at bottom of cleaner and press into top of hook (I).

1 - 12

1 - 13

1 - 14

Loop hose over top of caddy again.

Slide hose clip (J) toward end of hose.

Clip loose hose to hose in caddy. Press solution tube (K) into small clip on hose clip (inset).

Insert top of bare floor tool (available at	Snap stair/upholstery nozzle onto
additional cost if not included with your	caddy.
cleaner) through “loop” on caddy. Slide
tool down into place.

1 - 15

SpinScrub™ hand tool

(not included with all models)

The SpinScrub™ hand tool is shipped in a plastic bag for protection. To remove the bag before using the tool, open tool door.

1 - 16

Pull tool down and outward.

To reposition the tool, reverse this proce- dure.

1 - 17

The tool cover is designed with a break- away feature which allows it to snap free if it is pushed open too far.

To reattach, align hinges of cover with holes on sides of tool storage area. Snap door into place.