Hoover SteamVacTM V2TM manual If you have a

Page 15

S t o r a g e

Before storing:

Empty clean water tank and replace on deep cleaner.

Unused detergent can be stored in the detergent container.

Empty recovery tank and rinse thoroughly with clean water.

Allow brushes and underside of deep cleaner to air dry thoroughly before storing deep cleaner on a carpeted or wood surface.

Do not store deep cleaner with a full clean water tank in place.

Lubrication

The motor is equipped with bearings which contain sufficient lubrication for the life of the motor. The addition of lubricant could cause damage. Do not add lubricant to motor bearings.

Possible cause

5. If you have a

Possible solution

problemRec very tank full/automatic

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below.

Problem: Machine won’t run

Possible cause

Possible solution

Not firmly plugged in

Plug unit in firmly

No voltage in wall plug

Check fuse or breaker

Blown fuse/tripped breaker

Replace fuse/reset breaker

Problem: Low solution pick-up

Possible cause

Possible solution

Recovery tank full/automatic shut off engaged

Remove and empty recovery tank

Blockage in tool on end of hose

Remove tool and clear blockage

Recovery tank lid not on correctly

Make sure lid is on securely

Water tank empty, but detergent remains

Fill water tank

Problem: Clean solution won’t

dispense

Possible cause

Possible solution

Clean water tank not firmly in place

Make sure tank is securely locked in position

Clean water tank or detergent container empty

Refill container according to instruc- tions for surface being cleaned

Recovery tank lid not on correctly

Make sure lid is firmly in place

Pump needs to be “primed” (when using tool)

See “Before using tool” section, p.12

Problem: Brushes won’t rotate during

floor cleaning

Possible cause

Possible solution

Dirty filter screen on bottom of unit

Clean screen as shown in Fig. 3-2

Setting selector on OFF

Move setting selector to ON

Service

To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service

Center or Authorized Hoover Warranty Service Dealer (Depot) by:

checking the Service section of The Hoover Company on-line at www.hoover.com OR

checking the list of Factory Service Centers provided with this cleaner

OR

checking the Yellow Pages under “Vacuum Cleaners - Household” OR

calling 1-800-944-9200for an automated referral of authorized service outlet locations (U.S. only).

Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay.

If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone: 330-499-9499.

In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone: 1-800-263-6376.

Always identify your cleaner by the complete model number when request- ing information or ordering parts. (The model number appears on the bottom of the cleaner.)

15

Image 15
Contents Deep Cleaner Important Safeguards Assembly ContentsAttach upper handle Attach hose/cord hookAttach hose/tool caddy SpinScrub hand tool How to reattach tool coverStoring hose and tools To transport How to useON/OFF switch Handle release pedalAutomatic shut off Brush setting selectorWash/rinse switch Carrying handleHow to empty Turn deep cleaner off and unplug from electrical outletHoover detergent How to clean Before you begin cleaningAfter cleaning Turn brushes on or OFF as desired To clean nozzleRead Before you begin cleaning instructions on Do not clean over floor electrical out- letsAttach hose How to attach bare floor attachmentTo clean floor Unplug cleaner from electrical outletSelect tool How to attach toolsBefore using tool After using toolCleaning carpeted stairs To remove brushes MaintenanceDisconnect cleaner from electrical outlet Removable brushesIf you have a Full One Year Warranty Domestic Use