Quick pickups

To achieve a high lustre finish

1.Attach felt buffing pads over scrubbing-waxing-polishing brushes using

fasteners. Polish to a soft shine by guiding shampoo polisher in straight lines or with the grain of the wood. If more shine is desired proceed to step 2.

2.Remove felt buffing pads and attach high lustre polishing pads. Once again, guide the handle in straight lines or with the grain of the wood to achieve a high lustre finish.

To keep floors bright and shiny

Buff floor often to restore sheen and remove scratches and marks. This lengthens the time between waxings. Before buffing, use a vacuum cleaner to remove dust and dirt and a damp cloth to remove sticky particles. Stubborn spots, such as black heel marks, can be removed by rubbing gently with very fine steel wool dampened with wax.

If traffic areas need to be rewaxed and polished, and a solvent-base wax has been used on the floor, apply wax only to these areas then buff the entire floor.

Liquids spilled on hard surface floors, such as water, or soft drinks, can be picked up with your shampoo-polisher.

Before plugging unit into electrical outlet, attach scrubbing-waxing-pol- ishing brushes. Put a small amount of water into the tank. Move control button to the “WET PICKUP” position to remove liquid from floor. Rinse floor by moving control button to the “SCRUB-POLISH-SHAMPOO” position, and squeeze trigger to dispense clear water. Use “WET PICKUP” to remove rinse water.