Hoover Shampoo- Polisher Filter bar, Brushes, Felt and high lustre polishing pads, Defoamer cake

Page 19

!I

/

!

/

/

I

Filter bar

The filter bar, located between the two squeegees at the front of the shampoo-polisher base, protects the unit by collecting any large particles of dirt or residue. Clean filter bar after each use or during use if there is a decrease in the efficiency of the “WET PICKUP”.

Remove filter bar by placing the index fingers under each end and lifting up, as shown.

Clean off lint and dirt particles by holding filter bar under running water. Replace by snapping it in- to place between the squeegees.

Brushes

Wash scrubbing-waxing-polishing brushes and cleaning-waxing pads in a solution of hot water and detergent to remove wax. Rinse well. Hold shampoo brushes under warm running water to remove any lint that has collected. Shake brushes and pads to remove excess water. Place on paper towels (with brushes down) to dry. Allow brushes to dry com- pletely before reattaching them to unit.

Felt and high lustre polishing pads

The pads should be washed occasionally to remove wax. If shampoo- polisher does not glide easily when buffing floors, it may be due to an ac- cumulation of wax on pads. Pads should be washed in the same way as brushes. Shake the high lustre polishing pads several times while drying to restore fluffiness. Let pads dry thoroughly before using. Felt pads will be damaged if used while damp and neither felt nor high lustre polishing pads will polish well if they are not dry.

Defoamer cake

The defoamer cake, located inside upper part of tank housing, is necessary to reduce foam in the recovery tank.

The defoamer cake should be checked periodically. With normal use, it will last about one year.

Instructions for replacing the cake are imprinted on the back of the tank housing. To purchase replacement defoamer cakes, contact your nearest Hoover Service Center.

18

Image 19
Contents 0vi@@ Save Index Fill in and retainImportant Safeguards Unpacking Questions or Concerns? How to use AssemblyControl button Attach and remove brushes and pads TankTo fill tank To empty tankTo carry StoringCleaning floors Water method Do not use the water cleaning method on wood or cork floorsSolvent-base wax Solvent cleaning wax methodWaxing floors Water-base waxPolishing and buffing floors To achieve a high lustre finish Quick pickupsTo keep floors bright and shiny Check effect of shampoo brushes Shampooing carpet and rugsBefore you begin Test for colorfastnessVacuum thoroughly Shampoo inaccessible areasAttach rug shampoo accessory Ready, set, shampooShampoo carpet or rug Fill tankAllow carpet to dry Dry-cleaning carpetCompleting the task Brush pileBase of unit MaintenanceTank and tubing Furniture guardDefoamer cake Filter barBrushes Felt and high lustre polishing padsIf you have a problem ServiceLubrication Servicing of Double Insulated AppliaticesFloor care hints Accessories