Hoover Shampoo- Polisher Tank, To fill tank, To empty tank, Attach and remove brushes and pads

The tank

The tank has one section for stor- age of fresh cleaning solution and one section for storage of dirty solution that has been picked up from the floor.

To fill tank

A. Remove tank by pressing tank handle down and pulling tank for- ward.

B. Lift cap marked “FILL”. Pour premeasured cleaning solution into opening marked “CLEAN SOLUTION” until it reaches the “FULL” line on the tank.

To empty tank

To empty dirty solution, remove tank and pour from the opening marked “USED SOLUTION”.

Rinse used solution container with clear water. Clean solution may be emptied by opening “FILL” cap and pouring from the “CLEAN SOLUTION” opening.

Attach and remove brushes and pads

Disconnect from electric circuit before putting on or removing brushes.

Place shampoo-polisher upside down on a flat surface. Press each brush firmly down over brush shaft, rotating brush until a click indicates that it is in the cor- rect position. To remove-grasp center with thumb and fingers and lift up brush.

6