GE installation instructions SmartWater Filtration System GX1S50F Using Filter Gxrlqr

Page 4

Performance Data Sheet.

SmartWater Filtration System GX1S50F

Using Filter GXRLQR

This System has been tested according to NSF/ANSI 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI 42 and 53.

Actual performance may vary with local water conditions.

Do not use with water that is microbiologically unsafe or with water of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

Hoja de datos de funcionamiento.

Cartucho GXRLQR de sistema de filtración GE SmartWater GX1S50F

Este sistema se ha sometido a las pruebas NSF/ANSI 42 y 53 a fin de reducir las sustancias presentadas a continuación. Se redujo la concentración

de las sustancias indicadas en el agua que ingresan en el sistema a una concentración menor o igual al limite permitido para el agua que sale del sistema, como se especifica en NSF/ANSI 42 y 53.

El desempeño real puede variar de acuerdo a las condiciones locales del agua.

No use con agua que sea microbiológicamente insegura o de calidad desconocida sin una desinfección adecuada del sistema antes o después. Los sistemas certificados para la reducción de esporas pueden ser usados en agua desinfectada que podría contener esporas filtrables.

Standard No. 42: Aesthetic Effects / Estándar No. 42: Efectos estéticos

 

USEPA

Influent

Influent

Effluent

 

% Reduction

 

Min. Required

 

 

 

 

 

Parameter

MCL

Challenge Concentration

Average

Average

Maximum

Average

Minimum

Reduction

 

USEPA

Calidad del

Promedio

Effluyente

 

% de reducción

Reducción

 

 

 

 

 

Parámetro

MCL

influyente concentración

influyente

Promedio

Máximo

Promedio

Mínimo

mínima necesaria

Chlorine/Cloro

2.0 mg/L ± 10%

1.88 mg/L

<0.05 mg/L

0.06 mg/L

>97.26%

96.84%

≥50%

T & O

Particulate**/

≥ 10000 particles/

5700000 #/mL

30583 #/mL

69000 #/mL

99.52%

98.94%

≥85%

Partículas

 

partículas/mL

 

 

 

 

 

 

 

 

Standard No. 53: Health Effects / Estándar No. 53: Efectos relativos a la salud

 

 

 

USEPA

Influent

Influent

Effluent

 

% Reduction

 

Min. Required

 

 

 

 

 

Parameter

MCL

Challenge Concentration

Average

Average

Maximum

Average

Minimum

Reduction

 

USEPA

Calidad del

Promedio

Effluyente

 

% de reducción

Reducción

 

 

 

 

 

Parámetro

MCL

influyente concentración

influyente

Promedio

Máximo

Promedio

Mínimo

mínima necesaria

Turbidity/Turbidez

1 NTU***

11 ± 1 NTU***

11.18 NTU

0.315 NTU

0.049 NTU

97.12%

95.15%

0.5 NTU

Cysts/Quistes

99.95% red.

Min. 50000L

220000 #/L

0

0

>99.99%

>99.99%

>99.95%

Asbestos/Amianto

99% red.

107 and/y 108 fibers/fibras/L;

155 MF/L

<1

<1

>99.99%

>99.99%

99%

 

 

fibers/fibras >10 µm

 

 

 

 

 

 

 

 

long/de largo

 

 

 

 

 

 

Lead/Plomo,

0.015 mg/L

0.15 mg/L ± 10%

0.153 mg/L

<0.001

<0.001

>99.35%

>99.35%

0.010 mg/L

pH 6.5

 

 

 

 

 

 

 

 

Lead/Plomo,

0.015 mg/L

0.15 mg/L ± 10%

0.150 mg/L

<0.001

<0.001

>99.35%

>99.35%

0.010 mg/L

pH 8.5

 

 

 

 

 

 

 

 

Mercury/Mercurio,

0.002 mg/L

0.006 mg/L ± 10%

0.006 mg/L

0.00026

0.0005

98.72%

90.91%

0.002 mg/L

pH 6.5

 

 

 

 

 

 

 

 

Mercury/Mercurio,

0.002 mg/L

0.006 mg/L ± 10%

0.006 mg/L

0.0008

0.0015

98.72%

75.93%

0.002 mg/L

pH 8.5

 

 

 

 

 

 

 

 

Lindane

0.0002 mg/L

0.002 mg/L ± 10%

0.002 mg/L

0.000025

0.00007

98.72%

96.50%

0.0002 mg/L

Atrazine

0.003 mg/L

0.009 mg/L ± 10%

0.00873 mg/L

<0.002

<0.002

76.99%

75.31%

0.003 mg/L

*Tested using a flow rate of 0.78 gpm (2.95 l/min); pressure of 60 psig; pH of 7.5 ± 0.5; temp. of 68° ± 5°F (20° ± 3°C) / Probado utilizando una tasa de flujo de 0,78 gpm (2,95 l/min); presión de 60 psig; pH de 7,5 ± 0,5; temp. de 68° ± 5° F (20° ± 3° C)

**Measurement in particles/mL. Particles used were 0.5–1 microns. / Medición en partículas/mL. Las partículas usadas eran de 0,5–1 micrón.

***NTU—Nephelometric Turbidity Units / NTU—unidades de turbidez nefelométrica

Operating Specifications / Especificaciones de operación

Capacity: certified for up to 750 gallons (2,838 l); up to six months / Capacidad: certificado para hasta 750 galones (2838 l); hasta seis meses

Pressure requirement: 35–120 psi (2.8–8.2 bar) / Requerimientos de presión: 35–120 psi (2,8–8,2 bar)

Temperature: 33–100°F (0.6–38°C) / Temperatura: 33°–100° F (0,6°–38° C)

Flow rate: 0.78 gpm (2.95 l/min) / Tasa de flujo: 0,78 gpm (2,95 l/min)

Replacement Filter Canister/Estimated Replacement Costs

GXRLQR—Replacement filter canister $30–35

For replacement parts, call toll-free 800.626.2002.

Repuesto del cartucho del filtro/Costos estimados de reposición

GXRLQR—Repuesto del cartucho del filtro $30–35

Para repuestos, llame gratis al 800.626.2002 (EE.UU.).

4

Image 4
Contents Water Filtration System Sistema de Filtración de Agua Manual del propietarioLEA Todas LAS Instrucciones Antes DE Usar Installation Overview Water Filtration System Uses the Following CanisterGeneralidades sobre la instalación Model GX1S50FSmartWater Filtration System GX1S50F Using Filter Gxrlqr Replacement Filter Canister/Estimated Replacement CostsImportant Installation Recommendations Tools and Materials Required for InstallationContents Included with the Product Recomendaciones importantes para la instalaciónCold Water Supply Fitting Accesorio para el suministro de agua fríaFaucet Spout Installations see , Instalación del pico del grifo ver , páginaOption OpciónFaucet Installation Installation Steps refer to for clarificationInstalación del grifo Pasos para la instalación consulte la para aclaraciónMounting System Installation Mounting Using the Screw Provided FigMontaje del sistema Montaje utilizando el tornillo suministrado FigInstalling the Tubing Cómo instalar la tuberíaBattery Installation Instalación de la bateríaFlush Procedure Replacing the Filter CanisterCómo reemplazar el cartucho del filtro Procedimiento para lavarBefore you call for service… Antes de solicitar un servicio… La luz indicadora en la base del grifo está intermitenteOlor y/o sabor a cloro en el agua producida Instalado completamenteSoporte al consumidor Página Web de GE Solicite una reparaciónGarantías ampliadas Piezas y accesoriosSchedule Service Parts and AccessoriesGE Water Filtration System Warranty Consumer Support GE Appliances Website

GX1S50F specifications

The GE GX1S50F is an advanced water filtration system designed to provide clean and safe drinking water for households. This innovative system utilizes cutting-edge technologies to ensure that contaminants are effectively reduced while enhancing the overall taste and quality of the water.

One of the main features of the GE GX1S50F is its three-stage filtration process. The system first employs a sediment filter that captures large particles such as dirt, sand, and rust, ensuring that these impurities do not reach the subsequent stages. Following this, a carbon block filter takes over, which is adept at removing chlorine, lead, and other harmful chemicals that can affect the water's taste and safety. Finally, the system features a post-carbon filter that polishes the water, providing the finishing touch to ensure that every drop is crystal clear and fresh.

The GE GX1S50F is designed with user convenience in mind. Its compact size makes it easy to install, fitting seamlessly under most sinks without taking up excessive space. The system is also equipped with a simple shut-off valve, which allows users to quickly halt water flow during filter changes, minimizing mess and ensuring a straightforward replacement process.

Another significant characteristic of the GE GX1S50F is its durability and longevity. The filters are engineered to last up to six months, depending on usage and water quality, allowing households to enjoy cleaner water for a prolonged period without frequent replacements. This not only saves time but also adds to the system's cost-effectiveness.

In addition to its performance features, the GE GX1S50F is designed with sustainability in mind. By providing an efficient means of filtering tap water, the system reduces the reliance on single-use plastic water bottles, promoting an eco-friendly approach to water consumption.

Overall, the GE GX1S50F is a state-of-the-art water filtration solution that combines advanced technology with practical design. With its three-stage filtration process, easy installation, long-lasting filters, and commitment to sustainability, it offers an excellent choice for families looking to improve their drinking water quality while being mindful of their environmental impact.