GE GNUT05Z01 owner manual Repeat steps 2 through 8 for filter

Page 9
Lightly lubricate the o-ring seal in the sump with clean silicone grease. Be sure it is fully seated in its groove.
Hold the sump up to the filter head, aligning the center hole in the cartridge with the protrusion on the bottom of the head.

6

7

8 Being careful not to cross-thread, rotate the sump onto the filter head and tighten securely using the sump wrench tool provided.

NOTE: If the sump will not tighten up to the head, you may have the cartridge in upside down. Take the cartridge out and check for correct orientation.

9 Repeat steps 2 through 8 for filter II.

10 Turn on the filtered water faucet. Then, slowly open the water supply saddle valve and allow the filter housing to fill. While it is filling, press the filter vent valve to release air in the filter.

11 Close the filtered water faucet. Then check for leaks between the sump and the head.

NOTE: If leaking, turn off the water supply and turn on the filtered water faucet, or press the vent valve to depressurize the filter. Disassemble the filter and check the o-ring for cuts, flat spots, etc., and sealing surfaces for foreign material. Clean the o-ring and lightly lubricate with clean silicone grease. Carefully press into the groove in the sump.

12 If you are replacing the batteries, remove, properly discard and install two new “AA” alkaline batteries in the battery pack. Removing the batteries, or momentarily disconnecting the leadwires, resets the six month electronic timer.

13 The filter cartridges contain activated carbon, a black powder. When new, turn on the filtered water faucet and allow the fine, harmless carbon particles to purge from the cartridge. Turn off the faucet when you no longer see the particles in the filtered water.

Safety Information

Operating Instructions

Troubleshooting Tips

Customer Service

9

Image 9
Contents Water Filtration System Staple sales slip or cancelled check here Congratulations You Are Now Part of the GE FamilyWrite the model and serial numbers here Troubleshooting Tips GE & You Service PartnershipCustomer Service Safety InformationTroubleshooting Safety PrecautionsFilter II Options GE water filtration system uses two filter cartridges FilterHow much water you use About the water filtration systemIndicator light Filter Cartridge Replacement Repeat steps 2 through 8 for filter Procedure for flushing the GE Water Filtration System is Flush ProcedureBefore you call for service… Page Consumer Product Ownership Registration Important Mail Today Consumer Product Ownership Registration GE Will Replace GE Water Filtration System WarrantyWhat GE Will Not Cover One YearService Telephone Numbers In-Home Repair Service 800-GE-CARESTDD 800-TDD-GEAC