Harman-Kardon owner manual AVR 7550HD Technical Specifications, Audio Section

Page 67

AVR 7550HD TECHNICAL SPECIFICATIONS

Audio Section

Stereo Mode, Continuous Average Power (FTC)

100 Watts per channel, 20Hz–20kHz, @ <0.07% THD, both channels driven into 8 ohms

Seven-Channel Surround Modes

Power per Individual Channel

Front L & R channels:

85 Watts per channel

@ <0.07% THD, 20Hz–20kHz into 8 ohms

Center channel:

85 Watts @ <0.07% THD, 20Hz–20kHz into 8 ohms

Surround (L & R Side, L & R Back) channels: 85 Watts per channel

@ <0.07% THD, 20Hz–20kHz into 8 ohms

Input Sensitivity/Impedance

 

Linear (High-Level)

200mV/47k ohms

Signal-to-Noise Ratio (IHF-A)

100dB

Surround System Adjacent Channel Separation

Pro Logic® I/II

40dB

Dolby® Digital (AC-3)

55dB

DTS®

55dB

Frequency Response

 

@ 1W (+0dB, –3dB)

10Hz – 130kHz

High Instantaneous

 

Current Capability (HCC)

±60 Amps

Transient Intermodulation

 

Distortion (TIM)

Unmeasurable

Slew Rate

40V/µsec

FM Tuner Section

 

Frequency Range

87.5 –108.0MHz

Usable Sensitivity

IHF 1.3µV/13.2dBf

Signal-to-Noise Ratio

Mono/Stereo 70/68dB

Distortion

Mono/Stereo 0.2/0.3%

Stereo Separation

40dB @ 1kHz

Selectivity

±400kHz, 70dB

Image Rejection

80dB

IF Rejection

90dB

AM Tuner Section

 

Frequency Range

520–1720kHz

Signal-to-Noise Ratio

45dB

Usable Sensitivity

Loop 500µV

Distortion

1kHz, 50% Mod 0.8%

Selectivity

±10kHz, 30dB

Please register your AVR 7550HD at www.harmankardon.com. You’ll need the product’s serial number. At the same time, you can choose to be notified about new products and/or special promotions.

Video Section

 

 

Television Format

NTSC

 

Input Level/Impedance

1Vp-p/75 ohms

 

Output Level/Impedance

1Vp-p/75 ohms

 

Video Frequency Response

 

 

(Composite and S-Video)

10Hz–8MHz (–3dB)

 

Video Frequency Response

 

 

(Component Video)

10Hz–100MHz (–3dB)

 

HDMI

Version 1.3a with 10-bit Deep Color

General

 

 

Power Requirement

AC 120V/60Hz

 

Power Consumption

120W idle, 1405W maximum

 

(7 channels driven)

 

Dimensions

(Product)

(Shipping)

Width

17-5/16 inches (440mm)

20-1/2 inches (520mm)

Height

6-1/2 inches (165mm)

11 inches (280mm)

Depth

17-1/16 inches (435mm)

22-13/16 inches (580mm)

 

(Product)

(Shipping)

Weight

44 lb (20kg)

51 lb (23.3kg)

Depth measurement includes knobs, buttons and terminal connections. Height measurement includes feet and chassis.

Features, specifications and appearance are subject to change without notice.

Harman Kardon and Logic 7 are trademarks of Harman International Industries, Incorporated, registered in the United States and/or other countries. EzSet/EQ, Designed to Entertain and The Bridge II logo are trademarks of Harman International Industries, Incorporated.

Apple, iPod, iTunes and Macintosh are trademarks of Apple Inc., registered in the U.S. and other countries. iPod not included. “Made for iPod” means that an electronic accessory has been designed to connect specifically to iPod and has been certified by the developer to meet Apple performance standards. Apple is not responsible for the operation of this device or its compliance with safety and regulatory standards.

A-BUS is a registered trademark of Leisure Tech Electronics Pty Ltd.

Audiovox is a registered trademark of Audiovox Corporation.

Blu-ray Disc is a trademark of the Blu-ray Disc Association.

CEA is a registered trademark of the Consumer Electronics Association.

Manufactured under license from Dolby Laboratories. Dolby, the double-D symbol and Pro Logic

are registered trademarks of Dolby Laboratories. MLP Lossless is a trademark of Dolby Laboratories.

Manufactured under license under U.S. Patent #’s 5,451,942; 5,956,674; 5,974,380; 5,978,762; 6,226,616; 6,487,535; 7,003,467 and other U.S. and worldwide patents issued and pending. DTS, DTS-ES and DTS Neo:6 are registered trademarks, and DTS 96/24, DTS-HD, DTS-HD High Resolution Audio and DTS-HD Master Audio are trademarks, of DTS, Inc. © 1996-2007 DTS, Inc. All Rights Reserved.

EyeConnect is a trademark of Elgato Systems.

Faroudja DCDi Cinema is a trademark of Genesis Microchip Inc.

HD-DVD is a trademark of the DVD Format/Logo Licensing Corporation (DVD FLLC).

HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.

Intel is a trademark of Intel Corporation in the U.S. and other countries.

SACD is a trademark of Sony Corporation.

TiVo is a registered trademark of TiVo Inc.

Windows Media is a registered trademark of Microsoft Corporation in the United States and/or other countries.

XM, SIRIUS and all related marks and logos are trademarks of Sirius XM Radio Inc. and its sub- sidiaries. All other marks and logos are the property of their respective owners. All rights reserved. XM subscription sold separately. Taxes and a one-time activation fee may apply. XM tuner and home dock required (each sold separately) to receive the XM service. All programming and fees subject

to change. It is prohibited to copy, decompile, disassemble, reverse engineer, hack, manipulate or otherwise make available any technology or software incorporated in receivers compatible with the XM Satellite Radio System. Service not available in Alaska or Hawaii.

67

Image 67
Contents AVR7550HD Wet Location Marking Safety InformationImportant Safety Instructions Service Instructions Outdoor Use MarkingUnpacking Important Safety InformationTable of Contents Surround Modes IntroductionDigital Audio Inputs Supplied AccessoriesAudio Inputs Audio/Video InputsBack/Exit FRONT-PANEL ControlsResolution setting 480i, 480p, 720p, 1080i or 1080p On When the AVR is turned on, this LED turns whiteVideo Hdmi 1, 2, 3 Output XM Antenna REAR-PANEL ConnectionsREAR-PANEL Connections Front, Center and Surround Speaker Outputs AVR Power On Main Remote Control FunctionsZone Selector Main Remote Control Functions Main Remote Control Functions Menu Zone 2 Remote Control FunctionsSleep Settings IR Transmitter MuteZone 2 Remote Control Functions Harman International the Harman Kardon parent company Logic Introduction to Home TheaterTypical Home Theater System Multichannel AudioSubwoofer Connecting Source Devices to the AVRConnections Speaker ConnectionsDigital Video Video ConnectionsIncluding Dolby TrueHD and DTS-HD Master Audio Analog AudioRS-232 Serial Port AntennasFront Speaker Placement Speaker PlacementSubwoofer Placement Best audio connection for each source For Getting StartedSource Assignment Worksheet Getting Started Installation Select one or all of these methods for audio distribution Step Eleven Install a Multizone SystemConnect a Video Display Device or Switcher Connect IR Control Devices to the Zone 2 IR InputTo program the codes for a source device into the remote Step Twelve Plug in AC Power CordsStep Thirteen Insert Batteries in Remote Step Fourteen Program Sources Into the RemoteTo rename a key or device To change the device type of a Source SelectorTo learn individual key codes To delete a programmed or learned codeStep Fifteen Turn On the AVR 7550HD Select Automatic Setup-EzSet/EQ Initial SetupUsing the ON-SCREEN Menu System Configure the AVR 7550HD, Using EzSet/EQ II TechnologyAudio and Video Input Selection Set Up SourcesChannel Inputs You are now ready to begin enjoying your new receiver Operation Volume ControlDolby Volume Dolby Volume Calibration OffsetMute Function Sleep TimerHeadphones Using the TunerVideo display is in use XM Radio OperationInternet Radio USB PlaybackTo return to the beginning of the current track, press Recording Using Docking StationUsing The Bridge IPod Function Remote Control Key Network PlaybackNext Track Next 33 Previous Track Previous I IPod Manual ModeTV Out setting to take effect Play Pause Menu Back/Exit or Left Arrow SelectSurround Modes Menu Selecting a Surround ModeAudio Processing and Surround Sound Analog Audio SignalsDigital Audio Signals Advanced FunctionsManual Speaker Setup Dolby Surround SettingsVideo Game Logic 7 Game Number of Speakers Step Three Manual Setup MenuStep ONE Determine Speaker Crossover Step TWO Measure Speaker DistancesAdjust Speaker Distance Menu Adjust Crossover Frequencies MenuSub Mode Step Four Setting Channel Output Levels Manually Video Modes Video AdjustmentsHow to Adjust the Custom Picture Settings Sharpness Adjustment System SettingsSystem Information General AVR SettingsAdvanced Remote Control Functions Menu AppearanceMain Menu To end the command sequence, press the OK ButtonActivities Macros Back Light Remote ResetPunch-Through Programming Memory Processor ResetSymptom Cause Solution Troubleshooting GuideAppendix Table A2 Source Setting DefaultsTable A1 Recommended Source Component Connections Table A2 Table A3 Speaker/Channel Setting DefaultsBridge Table A4 Delay Setting DefaultsTable A5 Source Settings 0mSTable A6 Table A6 Audio Effects SettingsDefault Table A5Off Black Level Deinterlacing Film Mode Detect 302 Table A7 Video Modes SettingsTable A7 Source Input Device Type if changed Table A9 Remote Control CodesTable A8 Surround Modes Table A8Table A11 Network Settings Table A10 System SettingsTable A12 Zone 2 Settings Table A13 Surround Modes Surround Mode Description Incoming Bitstream or SignalTable A13 DTS 2/2/.0 or .1, 3/2/.0 or DTS-ES MatrixDTS Stereo Presentation DTS Neo6Subwoofer is used For multichannelAnalog Bypass Remote Control Function List Reference Radio Table A14 Remote Control Function ListAUX Table A14Audio Section AVR 7550HD Technical Specifications