_,iiiii_i_'_iiii_i SECTION 3 _........j , j ,,,,J CARE OF YOUR WATER SOFTENER
B. KEEPING THE WATER SOFTENER CLEAN
NOZZLE & VENTURI
A clean nozzle and venturi (FIG. 11) is a must for the softener to work right. This small unit moves brine from the salt storage tank to the resin tank during re-
generation. If it becomes plugged with sand, silt,
dirt, etc., the softener will not work and you will get hard water.
To get to the nozzle and venturi, remove the softener top cover. Be sure the softener is in service cycle (no
water pressure at nozzle and venturi).
1)Turn off the cap from the nozzle and venturi hous- ing.
2)Lift out the screen support and screen, do not lose the large
3)Then the nozzle and venturi. Wash and rinse the
parts in warm water until clean. If needed, use a small brush to remove iron or dirt. Also check and
clean the gasket, flow plugs and screens.
Carefully replace all parts in the correct order. Lu- bricate the
line and place in position. Install and tighten the
cap, by hand only. Do not overtighten and break the cap or housing.
IRON FROM RESIN BED
Your water softener takes hardness minerals (cal-
cium and magnesium) out of the water. Also, it can
control some "clear water" iron. See maximum al-
lowed in the specifications on page
put into a glass. After 15 to 30 minutes, the water be- gins to cloud or turn rust colored. A water softener WILL NOT remove any iron which makes the water cloudy or rusty as it comes from the faucet (called red water iron). To take red water iron out of water,
or over the maximum of clear water iron, an iron ill-
Cleaning Nozzle & Venturi
Cap .._
_ |
|
| |
Screen Support | _ |
|
|
Screen | ._ | , | |
|
| _ | Flow Plug |
Nozzle & Venturi | ._ | '_1_ |
|
Gasket | _._._ | o.._= | icreen |
IMPORTANT: Be sure _ | _ |
|
holes in the gasket are cen-
tered directly over the small holes in the nozzle & venturi
housing
(HVDC)
Nozzle & Venturi
Housing
*Install with numbered side up, concave
side down. Be sure the largest flow plug is
located in the nozzle & venturi housing.
ter or other equipment is needed. Your local Sears store has trained people to help you with iron water problems.
If your water supply has clear water iron, even
though less than the maximum allowed, regular
resin bed cleaning is needed. Your local Sears store has resin bed cleaner, Item No.
up in the soft water before 6 months, clean more
often. Printed instructions are on the resin bed cleaner bottle.
Problems, Questions? Call